Showing 1 - 5 results of 5 for search 'Tomáš Zlámal', query time: 0.02s Refine Results
  1. 1
    SURFACE MICROHARDENING STUDIES ON STEELS AFTER HIGH FEED MILLING

    SURFACE MICROHARDENING STUDIES ON STEELS AFTER HIGH FEED MILLING by Jana Petrů, Tomáš Zlámal, František Špalek, Robert Čep

    Published 2018-06-01
    Get full text
    Article
  2. 2
    IMPACT OF CUTTING TOOL GEOMETRY ON THE DYNAMIC LOAD OF SYSTEM IN THE MACHINING PROCESS OF NICKEL ALLOY 625

    IMPACT OF CUTTING TOOL GEOMETRY ON THE DYNAMIC LOAD OF SYSTEM IN THE MACHINING PROCESS OF NICKEL ALLOY 625 by Jiří Hajnyš, Tomáš Zlámal, Jana Petrů, Marek Pagáč, Anna Rudawska

    Published 2016-12-01
    Get full text
    Article
  3. 3
    The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625

    The effect of feed rate on durability and wear of exchangeable cutting inserts during cutting Ni-625 by Jana Petrů, Tomáš Zlámal, Robert Čep, Marek Sadílek, Dana Stančeková

    Published 2017-01-01
    Get full text
    Article
  4. 4
    The Tool Life and Coating-Substrate Adhesion of AlCrSiN-Coated Carbide Cutting Tools Prepared by LARC with Respect to the Edge Preparation and Surface Finishing

    The Tool Life and Coating-Substrate Adhesion of AlCrSiN-Coated Carbide Cutting Tools Prepared by LARC with Respect to the Edge Preparation and Surface Finishing by Tomáš Vopát, Martin Sahul, Marián Haršáni, Ondřej Vortel, Tomáš Zlámal

    Published 2020-02-01
    Get full text
    Article
  5. 5
    Evaluation of Residual Stresses after Irregular Interrupted Machining

    Evaluation of Residual Stresses after Irregular Interrupted Machining by Sarka Malotova, Robert Cep, Tomas Zlamal, Petr Mohyla, Andrej Czán, Aco Antić, Igor Budak, Lobonţiu Mircea

    Published 2018-01-01
    Get full text
    Article

Search Tools: