Improvement of weld lines and sink marks for plastic injection moulding by using software moldex [electronic resource] /

相似书籍

• Improvement of weld lines and sink marks for plastic injection moulding by using software moldex /
  由: 443725 Loo, Chee Tack, et al.
  出版: (2007)
• Design mould and simulation of plastic injection moulding of water tap using MOLDEX software and the Taguchi method /
  由: 325818 Beh, Chee Hong, et al.
  出版: (2007)
• Simulation on sink mark defect of plastic injection moulding of Proton Iswara outer door handle trim using moldex software and D.O.E. classical method /
  由: Tan, Sze Ling, et al.
  出版: (2008)
• Simulation of plastic injection moulding of handphone covers using moldex software and classical method /
  由: 458345 Liaw, Tsen Kwang, et al.
  出版: (2007)
• Simulation of plastic injection moulding of card holders using moldex software and the taguchi method /
  由: 322443 Choo, Tien Tean, et al.
  出版: (2007)