Comparative study of submerged friction stir welding of aluminium alloy using different cooling medium

Comparative study of submerged friction stir welding of aluminium alloy using different cooling medium

This study presents a comparative study on friction stir welding (FSW) of aluminium alloy using different cooling medium. Three types of cooling medium were used, namely air, water and coolant. These various types of cooling medium are used in order to compare the quality of the welding joint. Tensi...

Cur síos iomlán

Sonraí bibleagrafaíochta
Príomhchruthaitheoirí:	Nur Syafiqah, Nor Sofian, Luqman Hakim, Ahmad Shah
Formáid:	Conference or Workshop Item
Teanga:	English English
Foilsithe / Cruthaithe:	IET 2022
Ábhair:	TJ Mechanical engineering and machinery TL Motor vehicles. Aeronautics. Astronautics
Rochtain ar líne:	http://umpir.ump.edu.my/id/eprint/38595/1/Comparative%20study%20of%20submerged%20friction%20stir%20welding%20of%20aluminium%20alloy%20.pdf http://umpir.ump.edu.my/id/eprint/38595/2/Comparative%20study%20of%20submerged%20friction%20stir%20welding%20of%20aluminium%20alloy_FULL.pdf

Míreanna comhchosúla

The role of tool offset on the microstructure and mechanical properties of Al/Cu friction stir welded joints
de réir: Hou, Wentao, et al.
Foilsithe / Cruthaithe: (2020)

The role of pin eccentricity in friction stir welding of Al‑Mg‑Si alloy sheets : microstructural evolution and mechanical properties
de réir: Hou, Wentao, et al.
Foilsithe / Cruthaithe: (2022)

Prediction of tire friction
de réir: Muhammad Muhaimin, Shaari
Foilsithe / Cruthaithe: (2009)

Strain rate and microtexture analysis of rapid-quenched AA6061 friction stir welds produced with tool eccentricity
de réir: Luqman Hakim, Ahmad Shah, et al.
Foilsithe / Cruthaithe: (2022)

Skin friction reduction by micro bubbles in pipe flow
de réir: Erny Afiza, Alias
Foilsithe / Cruthaithe: (2012)

Development of diesel engines cooling system
de réir: Mohammad Naqib Amirul, Abdul Rashid
Foilsithe / Cruthaithe: (2012)

Design and development of 1-seated urban car chassis using aluminium
de réir: Fazliana, Fauzun
Foilsithe / Cruthaithe: (2010)

Computational crashworthy optimization of partially filled aluminium foam for automative side member
de réir: Salwani, Mohd Salleh
Foilsithe / Cruthaithe: (2013)

Car cooling system during parking using blowe
de réir: Amiruddin, Ahmad
Foilsithe / Cruthaithe: (2007)

Design and development of integrated chassis of one seated urban car using embedded aluminium and FRP
de réir: Noor Akmal, Zolkifli
Foilsithe / Cruthaithe: (2010)

Wear behavior of as-cast and heat treated triple particle size SiC reinforced aluminium metal matrix composites
de réir: Maleque, Md. Abdul, et al.
Foilsithe / Cruthaithe: (2009)

Evaporative cooling system for electric vehicles battery pack
de réir: Khalid, A. Hilmi, et al.
Foilsithe / Cruthaithe: (2013)

Nanofluids In Battery Cooling System
de réir: Lee, Chern Khai
Foilsithe / Cruthaithe: (2018)

Modeling magneto-rheological damper using neural network and simulated annealing
de réir: Mohamad Luqman, Zaki Monsarif
Foilsithe / Cruthaithe: (2013)

Simulation test of automotive alloy wheel using computer aided engineering software
de réir: Mohd Izzat Faliqfarhan, Baharom
Foilsithe / Cruthaithe: (2008)

Tribological (wear) properties of aluminum–silicon eutectic base alloy under dry sliding condition
de réir: Alias, Tuti Yasmin, et al.
Foilsithe / Cruthaithe: (2004)

U-Space ConOps Implementation in Malaysia
de réir: Mohd Ariff, Mohd Aifaa, et al.
Foilsithe / Cruthaithe: (2024)

Improvement of bus roof section
de réir: Ahmad Farhan Hakim, Azmi
Foilsithe / Cruthaithe: (2008)

U-Space ConOps Implementation in Malaysia
de réir: Mohd Ariff, Mohd Aifaa, et al.
Foilsithe / Cruthaithe: (2024)

Thermal analysis of 6061 wrought aluminium alloy using cooling curve analysis-computer aided (CCA-CA) method
de réir: Nor Hanisah, Husain, et al.
Foilsithe / Cruthaithe: (2020)

Study On The Effects Of Alternative-Kerosene Fuel Mixture On Combustion Spray Characteristics For Different Spray Half Cone Angle
de réir: Roslan, Farah Syafiqah
Foilsithe / Cruthaithe: (2018)

A New Design and Simulation of Smart Sensing for Emergency Vehicle
de réir: Mohamad, Mahmod Abd Hakim, et al.
Foilsithe / Cruthaithe: (2024)

Tak sangka pesawat terhempas
de réir: Omar, Shah Nizam
Foilsithe / Cruthaithe: (2010)

Gear ratio investigation of automotive manual transmission
de réir: Muhamad Amir Shah, Arif Harun
Foilsithe / Cruthaithe: (2007)

Experimental and simulation Studies of a Two Seater Light Aircraft
de réir: Ishak, Iskandar Shah, et al.
Foilsithe / Cruthaithe: (2006)

Sangka gimik : Majlis perasmian karnival konvokesyen gempar letupan kuat pesawat
de réir: Hussin, Mohamad
Foilsithe / Cruthaithe: (2010)

Time headway study on exclusive motorcycle lane
de réir: Yuen, C.W., et al.
Foilsithe / Cruthaithe: (2011)

Preference of University students towards cycling in campus
de réir: Raja Abdul Aziz, R.S.
Foilsithe / Cruthaithe: (2011)

Intercity bus transportation system and its competition in Malaysia
de réir: Adji, B.M., et al.
Foilsithe / Cruthaithe: (2011)

Cruise control in automobile/car
de réir: Sobrie, Mohd Kamal, et al.
Foilsithe / Cruthaithe: (2013)

Car navigation system (mapping system)
de réir: Yong, Hiong Ai, et al.
Foilsithe / Cruthaithe: (2013)

Automated guided vehicles (AGVS)
de réir: Joferi, Ahmad Firdhaus, et al.
Foilsithe / Cruthaithe: (2013)

Climate control utilizing solar powered ventilation system for parked car
de réir: Tengku Ahmad, Tengku Marissa
Foilsithe / Cruthaithe: (2013)

Application of unmmaned aerial vehicle (UAV), infiltration test and stream gauging for determining of hydrology paremeters at Kampung Lama Orang Asli, Kangkar Senangar, Batu Pahat Johor
de réir: Tajul Baharuddin, Mohamad Faizal, et al.
Foilsithe / Cruthaithe: (2020)

Enhancing fuel burning efficiency by regulate spark plug voltage supply
de réir: Mohd Ariffin, Maslina
Foilsithe / Cruthaithe: (2013)

The impact of organizational and individual factors on safety climate : a study in aviation industry
de réir: Diana Atton Anak Paul
Foilsithe / Cruthaithe: (2008)

Vehicles Speed Estimation Model from Video Streams for Automatic Traffic Flow Analysis Systems
de réir: Arriffin, Maizatul Najihah, et al.
Foilsithe / Cruthaithe: (2023)

UAV-based weed detection in Chinese cabbage using deep learning
de réir: Pauline Ong, Pauline Ong, et al.
Foilsithe / Cruthaithe: (2023)

Effect of Reynolds number on the wake of a Next-Generation High-Speed Train using CFD analysis
de réir: Mohammad Arafat, Mohammad Arafat, et al.
Foilsithe / Cruthaithe: (2023)

EEG-Based Brain-Machine Interface (BMI) for Controlling Mobile Robots: The Trend of Prior Studies
de réir: Murali Krishnan, et al.
Foilsithe / Cruthaithe: (2015)