Modelling and analyzing of an active magnetic bearing

Modelling and analyzing of an active magnetic bearing

This project presents a model of an active magnetic bearing which is design and analyzed using COMSOL Multiphysics and also analysis of an active magnetic bearing control system by using MatLab SimuLink. Magnetic flux from an active magnetic bearing is produced when a current is flowing in winding o...

Bibliográfalaš dieđut
Váldodahkki:	Suhail Hadri, Shamsudin
Materiálatiipa:	Undergraduates Project Papers
Giella:	English
Almmustuhtton:	2013
Fáttát:	TJ Mechanical engineering and machinery
Liŋkkat:	http://umpir.ump.edu.my/id/eprint/6534/4/Modelling%20and%20analyzing%20of%20an%20active%20magnetic%20bearing.pdf

Geahča maid

Modern and intelligent controller for a magnetic bearing system
Dahkki: Samsudin, Sharatul Izah
Almmustuhtton: (2006)

Hydraulic bearing puller
Dahkki: Abu Bakar, Nor Hidayah, et al.
Almmustuhtton: (2017)

Acoustic emission analysis for bearing condition monitoring
Dahkki: Mohd Helmi, Rasid
Almmustuhtton: (2013)

Development of autogrease electric motor’s bearing system
Dahkki: Ahmad Fatihy, Mohd Subbri
Almmustuhtton: (2012)

Analyze extreme wind speed in peninsular Malaysia
Dahkki: Aisyatul Azlin, Sitam
Almmustuhtton: (2014)

Design and analyzing of small blade wind turbine
Dahkki: Zarina, Amat Jafar
Almmustuhtton: (2009)

Bearing fault detection using discrete wavelet transform
Dahkki: Syahril Azeem Ong, Haji Maliki Ong
Almmustuhtton: (2012)

Signal analysis of vibration measurements for condition monitoring of bearings
Dahkki: Chebil, Jalel, et al.
Almmustuhtton: (2010)

Visual inspection on premature failure of electric motor bearings
Dahkki: Edy Sutjipto, Agus Geter, et al.
Almmustuhtton: (2011)

Development of graphical user interface (GUI) for bearing fault detection
Dahkki: Syahidah Nafisa, Abdul Malik
Almmustuhtton: (2013)

Clustering of frequency-based vibration signal for bearing fault detection
Dahkki: Chia, Ming Xuan
Almmustuhtton: (2013)

Development of bearing fault detection system based on vibration signal
Dahkki: Ghazali, M. F., et al.
Almmustuhtton: (2017)

Nonlinear analysis of rotating machinery running on foil-air bearing
Dahkki: Hassan, Mohd Firdaus

Wavelet decomposition for the detection and diagnosis of faults in rolling element bearings
Dahkki: Jalel, chebil
Almmustuhtton: (2009)

Surface Degradation Analysis Of Roller Bearing
Dahkki: Yusof, Nurul Farhana Mohd
Almmustuhtton: (2012)

Micropitting And Wear Assessment Of Roller Bearing
Dahkki: Hamidi, Muhammad Nafiz
Almmustuhtton: (2022)

A wavelet decomposition analysis of vibration signal for bearing fault detection
Dahkki: Che Ku Eddy Nizwan, Che Ku Husin, et al.
Almmustuhtton: (2013)

An experimental and theoretical analysis of a foil-air bearing rotor system
Dahkki: Bonello, P., et al.
Almmustuhtton: (2018)

Performance Evaluation of BPSO & PCA as Feature Reduction Techniques for Bearing Fault Diagnosis
Dahkki: Faysal, Atik, et al.
Almmustuhtton: (2022)

Clustering of Frequency Spectrum from Different Bearing Fault using Principle Component Analysis
Dahkki: Mohd Fadhlan, Mohd Yusof, et al.
Almmustuhtton: (2016)

Application of a finite element method to predict fatigue life of the knee mobile bearing
Dahkki: Sin Jian, E. L., et al.
Almmustuhtton: (2018)

The modification of the perforated plate in the fluidized-bed combustor to analyze heat convection rate and temperature
Dahkki: Erdiwansyah, ., et al.
Almmustuhtton: (2021)

Investigation of Fatigue Failure Performance of Ankle Implant Mobile Bearing using Finite Element Method
Dahkki: Rosdi, Daud, et al.
Almmustuhtton: (2019)

Analyzing long-term reliability and potential of organic eutectic Phase Change Material as thermal batteries
Dahkki: Jacob, Jeeja, et al.
Almmustuhtton: (2023)

Porosity Detection by Analyzing arc Sound Signal Acquired During the Welding Process of Gas Pipeline Steel
Dahkki: Mohd Fadhlan, Mohd Yusof, et al.
Almmustuhtton: (2016)

Iron oxide reduction by graphite and torrefied biomass analyzed by TG-FTIR for mitigating CO2 emissions
Dahkki: Ubando, Aristotle T., et al.
Almmustuhtton: (2019)

Bearing strength behaviour of bridge concrete pedestal with confined reinforcements / Mohd Raizamzamani Md Zain...[et al.]
Dahkki: Md Zain, Mohd Raizamzamani, et al.
Almmustuhtton: (2019)

Theory and derivation of unsymmetrical rotor equation of the foil-air bearing rotor system and its validation with experiment data
Dahkki: M. F., Hassan
Almmustuhtton: (2019)

Mechanical and biocompatibility analyses of metabiomaterials cobalt chrome molybdenum manufactured by selective laser melting for load bearing implant
Dahkki: Siti Rohaida, Mohamed
Almmustuhtton: (2017)

Mathematical Modeling on Aligned Magnetic Field of Two-Phase Dusty Casson Fluid
Dahkki: N. S., Arifin, et al.
Almmustuhtton: (2017)

Effect of Magnetic Flux on Rotor-Stator Arrangement of Neodymium Permanent Magnet
Dahkki: A. R., Razali, et al.
Almmustuhtton: (2015)

Residual stress and wear studies of deep cryogenically treated SAE 52100 bearing steel / M. Shunmuga Priyan and R. Sri Siva
Dahkki: Priyan, M. Shunmuga, et al.
Almmustuhtton: (2019)

Intelligent estimation of uncertainty bounds of an active magnetic bearings using ANFIS
Dahkki: M. Raafat, Safanah, et al.
Almmustuhtton: (2011)

Analysis Of Vibration Signals And Surface Characteristics Of Cylindrical Roller Bearing
Dahkki: Ahmad, Andree
Almmustuhtton: (2014)

Modeling and control of active suspension using pismic and SMC
Dahkki: Suaib, N. M., et al.
Almmustuhtton: (2008)

Monitoring and prediction of bearing failure by acoustic emission and neural network
Dahkki: Mahamad, Abd Kadir
Almmustuhtton: (2005)

Nickel nanowire: magnetic ordering synthesis
Dahkki: Mahendran, Samykano, et al.
Almmustuhtton: (2018)

Ignition mechanism analyzed through transient species measurements and its correlation with O-D and 3-D simulations for PRF and toluene n-heptane mixture
Dahkki: Mohd Adnin, Hamidi
Almmustuhtton: (2016)

An intelligent framework for modelling and active vibration control of flexible structures
Dahkki: Mohd. Hashim, Siti Zaiton
Almmustuhtton: (2004)

Development of portable magnetic clampingfor lathe machine
Dahkki: Ab Wahab, N., et al.
Almmustuhtton: (2018)