A Technical Device for Determining the Predispositions of Students—Air Traffic Controllers and Pilots during Multitasking Training

The specific professions of aviation personnel include the professions of the pilot and air traffic controller. These occupations are specific in that while performing their work, they must be able to simultaneously operate the devices in the handling area and in the pedipulation area, supplemented...

Full description

Bibliographic Details
Main Authors: Matej Antosko, Pavol Lipovsky
Format: Article
Language:English
Published: MDPI AG 2022-11-01
Series:Applied Sciences
Subjects:
Online Access:https://www.mdpi.com/2076-3417/12/21/11171
Description
Summary:The specific professions of aviation personnel include the professions of the pilot and air traffic controller. These occupations are specific in that while performing their work, they must be able to simultaneously operate the devices in the handling area and in the pedipulation area, supplemented by acoustic sensations in the form of correspondence between flying and ground stations. The performance requirements of pilots and air traffic controllers place high demands on their health, psychological condition, attention, and concentration, due to being in constant pursuit of minimization of erroneous decisions, otherwise defined as the human factor in aviation. This article is focused on the development and testing of a technical device for measuring the relative error rate of students in multitasking tasks in preparation for employment. The main result is a designed technical device with hardware (HW) and software (SW) parts. An experimental method was used to measure the qualitative and quantitative performance indicators of the test subjects. The results of the experiment were observed and evaluated based on the analytical-synthetic method based on critical thinking. By comparing and abstracting the measured data, the reference values of the performance indicators of the tested subjects were determined. The selection of the final sample of subjects consisted of two phases. In the first phase, questionnaires were evaluated, and in the second phase, reaction time measurements during multitasking tasks using technical equipment were evaluated. Based on the measurements, an error ratio was defined, which could be graphically represented. The testing proved the full functionality of the designed technical equipment for these purposes in aviation education.
ISSN:2076-3417