3D Hybrid Numerical Model of Residual Stresses: Numerical—Sensitivity to Cutting Parameters When Turning 15-5PH Stainless Steel
This paper investigates the residual stresses induced by a longitudinal turning operation in 15-5PH martensitic stainless steel. An experimental investigation has quantified the sensitivity of residual stresses to cutting speed, feed, tool geometry and tool flank wear. In parallel, a 3D hybrid model...
Main Authors: | Alexandre Mondelin, Frédéric Valiorgue, Joël Rech, Michel Coret |
---|---|
Format: | Article |
Language: | English |
Published: |
MDPI AG
2021-07-01
|
Series: | Journal of Manufacturing and Materials Processing |
Subjects: | |
Online Access: | https://www.mdpi.com/2504-4494/5/3/70 |
Similar Items
-
Cutting Forces and Chip Shaping When Finish Turning of 17-4 PH Stainless Steel under Dry, Wet, and MQL Machining Conditions
by: Kamil Leksycki, et al.
Published: (2020-09-01) -
The Effect of Coatings on Cutting Force in Turning of C45 Steel
by: Jaroslav Kovalčík, et al.
Published: (2022-01-01) -
Numerical Analysis of the Temperature Field in the Cutting Zone in Continuous and Discontinuous Metal Cutting by Turning
by: Miroslav Lučić, et al.
Published: (2020-01-01) -
Development of a turn-to-turn fault detection method in the three-phase transformer's winding
by: R. G. Mustafin, et al.
Published: (2021-05-01) -
Investigation of the relationship between cutting force and cutting tool wear with technological parameters when turning hardening without cooling SKD11 steel
by: Hoàng Thị Diệu, et al.
Published: (2023-09-01)