Startup and initial operation of an MLE-MABR treating municipal wastewater
A 630 m3/d pilot plant was installed at Subiaco WRRF to determine design and operational parameters of a hybrid Modified Ludzack-Ettinger – Membrane Aerated Biofilm Reactor (MLE-MABR) configuration. Two commercial ZeeLung MABR cassettes were installed in series in the anoxic zone and the pilot was f...
| Main Authors: | , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
IWA Publishing
2022-02-01
|
| Series: | Water Science and Technology |
| Subjects: | |
| Online Access: | http://wst.iwaponline.com/content/85/4/1155 |
| Summary: | A 630 m3/d pilot plant was installed at Subiaco WRRF to determine design and operational parameters of a hybrid Modified Ludzack-Ettinger – Membrane Aerated Biofilm Reactor (MLE-MABR) configuration. Two commercial ZeeLung MABR cassettes were installed in series in the anoxic zone and the pilot was fed with primary effluent (averaging COD 601 mg/L, TKN 68.5 mg/L and 17–29 °C). A nitrifying biofilm was developed within 3 weeks and the nitrous oxide (N2O) gas emissions from the MABR exhaust gas proved to be a reliable parameter to assess biofilm development. Both MABRs achieved the average nitrification rate (NR) of 3.7 gNH4-N/m2.d when air flow was 8.6 and 11.2 Nm3/h to MABR1 and MABR2 respectively, which reached a maximum oxygen transfer rate of 17.4 gO2/m2.d. Biofilm thickness was controlled via air scouring and intermittent coarse bubble mixing (90 s on/90 s off). This paper discusses the startup strategy, minimum requirements for process monitoring, impact of different air flow conditions, ORP and mixing patterns on performance efficiency over a 22-week period. HIGHLIGHTS
Nitrifying biofilm is developed in 3 weeks in an MABR.;
N2O emissions from MABR exhaust gas is a reliable parameter for start-up monitoring.;
Monitoring of O2% in the MABR exhaust gas coupled with ammonia concentration in the wastewater are satisfactory parameters for process performance evaluation.;
It appears possible to install MABR technology in the anoxic zone of an MLE process with no major process changes.; |
|---|---|
| ISSN: | 0273-1223 1996-9732 |