An experimental study of rotational pressure loss in rotor-stator gap

An experimental study of rotational pressure loss in rotor-stator gap

The annular gap between rotor and stator is an inevitable flow path of a throughflow ventilated electrical machine, but the flow entering the rotor-stator gap is subjected to the effects of rotation. The pressure loss and volumetric flow rate across the rotor-stator gap were measured and compared be...

Descripció completa

Dades bibliogràfiques
Autors principals:	Yew Chuan Chong, Dave A. Staton, Markus A. Mueller, John Chick
Format:	Article
Idioma:	English
Publicat:	KeAi Communications Co., Ltd. 2017-06-01
Col·lecció:	Propulsion and Power Research
Matèries:	Pressure drop Flow network analysis Rotating machinery Rotational pressure drop Rotor-stator gap Annular gap Electrical machines
Accés en línia:	http://www.sciencedirect.com/science/article/pii/S2212540X17300263

Ítems similars

Research of Cavitation at High Shear Stress
per: Csuka Zoltán, et al.
Publicat: (2016-07-01)

Numerical and Experimental Study on the Effect of Rotor–Stator Distance on Rotor–Stator Interaction Strength within Mixed-Flow Centrifugal Pumps
per: Feng Han, et al.
Publicat: (2022-08-01)

Leakage Vortex Progression through a Guide Vane’s Clearance Gap and the Resulting Pressure Fluctuation in a Francis Turbine
per: Nirmal Acharya, et al.
Publicat: (2021-07-01)

Substitution of equations for evaluation of energy consumption in rotor-stator mixers
per: Олександр Семінський
Publicat: (2022-10-01)

Introducing Improved Iterated Extended Kalman Filter (IIEKF) to Estimate the Rotor Rotational Speed, Rotor and Stator Resistances of Induction Motors
per: Bijan Moaveni, et al.
Publicat: (2023-01-01)

Effect of Channel Orientation and Rib Pitch-to-Height Ratio on Pressure Drop in a Rotating Square Channel with Ribs on Two Opposite Surfaces
per: Prabhu S. V., et al.
Publicat: (2005-01-01)

Effect of Channel Orientation and Rib Pitch-to-Height Ratio on Pressure Drop in a Rotating Square Channel with Ribs on Two Opposite Surfaces
per: S. V. Prabhu, et al.
Publicat: (2005-01-01)

An Analysis of the Effect of Cavitation on Rotor–Stator Interaction in a Bidirectional Bulb Tubular Pump
per: Yucheng Zhou, et al.
Publicat: (2025-01-01)

Modulation effect on rotor-stator interaction subjected to fluctuating rotation speed in a centrifugal pump
per: Shiwei Ni, et al.
Publicat: (2023-12-01)

Forced Response Analysis of an Embedded Compressor Rotor Induced by Stator Disturbances and Rotor–Stator Interactions
per: Yun Zheng, et al.
Publicat: (2023-04-01)

Study on Multidegree-of-Freedom Ultrasonic Motor Using Vibration Mode Rotation of Metal Spherical Stator
per: Ai Mizuno, et al.
Publicat: (2022-01-01)

Project of Economically Profitable Technological Process of Production of Rotor and Stator Plates of Inductive Position Sensor by Blanking and Roll Bending
per: Radek ČADA, et al.
Publicat: (2013-12-01)

Non-Isothermal Hydrodynamic Characteristics of a Nanofluid in a Fin-Attached Rotating Tube Bundle
per: Mashhour A. Alazwari, et al.
Publicat: (2021-05-01)

Axial Gap Studies on the Flow Behavior and Performance of a Counter Rotating Turbine
per: R. Subbarao, et al.
Publicat: (2020-01-01)

Stator current identification in generator among single and composite faults composed by static air‐gap eccentricity and rotor inter‐turn short circuit
per: Yu‐Ling He, et al.
Publicat: (2023-02-01)

Analysis of rotors supported upon many bearings /
per: 437999 Morton, P. G.

Design and analysis of a novel rotor-segmented axial-field switched reluctance machine
per: Wei Sun, et al.
Publicat: (2017-09-01)

Appraisal of the Flooding Behaviour of Rotating Packed Beds
per: Usman Garba, et al.
Publicat: (2024-09-01)

A CONSTRUCTIVE SOLUTION FOR A ROTATING MACHINE WITH PROFILED ROTORS THAT TRANSPORT FLUIDS
per: Mariana Mirela STOICAN (PRISECARU), et al.
Publicat: (2020-05-01)

Numerical Analysis of Altered Parallel Flow Heat Exchanger with Promoted Geometry at Multifarious Baffle Prolongs
per: Mehmet Akif Kartal, et al.
Publicat: (2024-04-01)

Comparison of the effects of surface roughness and confinement on rotor–stator cavity flow
per: M. Özkan, et al.
Publicat: (2017-01-01)

Numerical Investigation of Rotor and Stator Matching Mode on the Complex Flow Field and Pressure Pulsation of a Vaned Centrifugal Pump
per: Leilei Du, et al.
Publicat: (2024-05-01)

CFD Simulation of Dry Pressure Drop in a Cross-Flow Rotating Packed Bed
per: Chao Zhang, et al.
Publicat: (2021-10-01)

Experimental and Numerical Investigation of a Novel Vortex Reducer in a Co-Rotating Cavity of Aeroengines
per: Wenjie Shen, et al.
Publicat: (2024-03-01)

Case Study of Pump Failure Due to Rotor-Stator Interaction
per: Hideo Ohashi
Publicat: (1994-01-01)

UNSTEADY FLOW THROUGH THE GAP OF SAVONIUS TURBINE ROTOR
per: JERZY ŚWIRYDCZUK, et al.
Publicat: (2011-01-01)

Influence of static and dynamic rotor/stator misalignments in axial flux magnetically geared machines
per: Mohammed F. Hamad Khatab, et al.
Publicat: (2019-06-01)

Analysis of Rotor-Stator Interaction of a Pump-Turbine with Splitter Blades in a Pump Mode
per: Haiqin Song, et al.
Publicat: (2020-09-01)

Performance Characteristics of a Dual-Stator, Spoke-Type Permanent Magnet Vernier Machine with Support Bar
per: Jang-Hyun Park, et al.
Publicat: (2021-02-01)

Enhancement of Rotor Loading and Suppression of Stator Separation through Reduction of the Blade–Row Gap
per: Zhuo Wang, et al.
Publicat: (2023-03-01)

Influence of Blade Leading-Edge Shape on Cavitation in a Centrifugal Pump Impeller
per: Ran Tao, et al.
Publicat: (2018-09-01)

Review of Core Annular Flow
per: Baoshan Xie, et al.
Publicat: (2023-02-01)

Numerical Investigation of the Effect of Hub Gaps on the 3D Flows Inside the Stator of a Highly Loaded Axial Compressor Stage
per: Guangfeng An, et al.
Publicat: (2022-09-01)

Investigation of effective parameters on hydrodynamics of rotating packed bed using computational fluid dynamics
per: Ali Reza Miroliaei, et al.
Publicat: (2019-12-01)

Effect of Rotational Speed Variation on the Flow Characteristics in the Rotor-Stator System Cavity
per: Zhizhou Zhao, et al.
Publicat: (2021-11-01)

Regular and Chaotic Vibrations of a Nonlinear Rotor-Stator System
per: Urszula Ferdek
Publicat: (2024-11-01)

Unconventional Structures of Asynchronous Motors with Two Stators and Single-Rotor Radial Air Gaps in the Context of Their Applicability Assessment
per: Mihail-Florin Stan, et al.
Publicat: (2024-12-01)

Consequences of Flux Gap on Intriguing Features of Modular Stator Inset Permanent Magnet Consequent Pole Synchronous Machine
per: Wasiq Ullah, et al.
Publicat: (2022-01-01)

Stator-Rotor Contact Force Estimation of Rotating Machine
per: Mark Spiller, et al.
Publicat: (2021-06-01)

Modeling and Analysis of Double Stator Slotted Rotor Permanent Magnet Generator
per: Suhairi Rizuan Che Ahmad, et al.
Publicat: (2017-03-01)