| Summary: | Inconel 625 (IN625) superalloys can be easily fabricated by the laser-based powder bed fusion (PBF-LB/M) process, allowing the production of components with a high level of design freedom. However, one of the main drawbacks of the PBF-LB/M process is the control over thermally induced stresses and their mitigation. A standard approach to prevent distortion caused by residual stress is performing a stress-relieving (SR) heat treatment before cutting the parts from the building platform. Differently from the cast or wrought alloy, in additively manufactured IN625, the standard SR at 870 °C provokes the early formation of the undesirable δ phase. Therefore, this unsuitable precipitation observed in the PBF-LB/M material drives the attention to develop a tailored SR treatment to minimise the presence of undesirable phases. This work investigates SR at lower temperatures by simultaneously considering their effects on residual stress mitigation, microstructural evolution, and mechanical properties. A multiscale approach with cantilever and X-ray technologies was used to investigate how the residual stress level is affected by SR temperature. Moreover, microstructural analyses and phase identifications were performed by SEM, XRD, EBSD, and DSC analyses. Finally, mechanical investigations through microhardness and tensile tests were performed as well. The results revealed that for the additively manufactured IN625 parts, an alternative SR treatment able to mitigate the residual stresses without a massive formation of δ phase could be performed in a temperature range between 750 and 800 °C.
|
|---|