| Summary: | The study of in situ stress from image logs is a key factor for understanding regional stresses and the exploitation of hydrocarbon resources. This work presents a comprehensive geomechanical analysis of two eastern Algerian hydrocarbon fields to infer the magnitudes of principal stress components and stress field orientation. Acoustic image logs and borehole measurements were used in this research to aid our understanding of regional stress and field development. The studied In-Adaoui and Bourarhat fields encompass a combined thickness of 3050 m of Paleozoic and Mesozoic stratigraphy, with the primary reservoir facies in the Ordovician interval. The Ordovician sandstone reservoir interval indicates an average Poisson’s ratio (<i>v</i>) of 0.3, 100–150 MPa UCS, and 27–52 GPa Young’s modulus (E). Direct formation pressure measurements indicate that the sandstone reservoir is in a hydrostatic pore pressure regime. Density-derived vertical stress had a 1.1 PSI/feet gradient. Minimum horizontal stress modeled from both Poisson’s ratio and an effective stress ratio-based approach yielded an average 0.82 PSI/feet gradient, as validated with the leak-off test data. Drilling-induced tensile fractures (DITF) and compressive failures, i.e., breakouts (BO), were identified from acoustic image logs. On the basis of the DITF criterion, the maximum horizontal stress gradient was found to be 1.57–1.71 PSI/feet, while the BO width-derived gradient was 1.27–1.37 PSI/feet. Relative stress magnitudes indicate a strike-slip stress regime. A mean <i>S<sub>HMax</sub></i> orientation of N130°E (NW-SE) was interpreted from the wellbore failures, classified as B-quality stress indicators following the World Stress Map (WSM) ranking scheme. The inferred stress magnitude and orientation were in agreement with the regional trend of the western Mediterranean region and provide a basis for field development and hydraulic fracturing in the low-permeable reservoir. On the basis of the geomechanical assessments, drilling and reservoir development strategies are discussed, and optimization opportunities are identified.
|
|---|