An optimization of injecting system in die casting
After many years of development, die casting technology of metallic materials has been matured. In this paper,the lower-support and its injecting system were created with commercial software. And then the simulation software FLOW3D was applied to study the flow behavior of the melt during injection...
| Main Authors: | , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Foundry Journal Agency
2005-05-01
|
| Series: | China Foundry |
| Subjects: | |
| Online Access: | http://www.foundryworld.com/uploadfile/20094756684593.pdf |
| Summary: | After many years of development, die casting technology of metallic materials has been matured. In this paper,the lower-support and its injecting system were created with commercial software. And then the simulation software FLOW3D was applied to study the flow behavior of the melt during injection filling process. Both temperature field and defect distribution were simulated. Based on these results, the better injecting system with two additional overflows wasadopted. |
|---|---|
| ISSN: | 1672-6421 |