| Summary: | On 3 August 2014, an Mw 6.2 earthquake occurred in Ludian, Yunnan Province, China (27.245° N 103.427° E). This damaging earthquake caused approximately 400 fatalities, 1800 injuries, and the destruction of at least 12,000 houses. Using air temperature data of the National Center for Environmental Prediction (NCEP) and the tidal force fluctuant analysis (TFFA) method, we derive the temperature variations in multiple air layers between before and after the Ludian earthquake. In the spatial range of 30° × 30° (12°–42° N, 88°–118° E) of China, a thermal anomaly appeared only on or near the epicenter before earthquake, and air was heated from the land, then uplifted by a heat flux, and then cooled and dissipated upon rising. With the approaching earthquake, the duration and range of the thermal anomaly during each tidal cycle was found to increase, and the amplitude of the thermal anomaly varied with the tidal force potential: air temperature was found to rise during the negative phase of the tidal force potential, to reach peak at its trough, and to attenuate when the tidal force potential was rising again. A significance test supports the hypothesis that the thermal anomalies are physically related to Ludian earthquakes rather than being coincidences. Based on these results, we argue that the change of air temperature could reflect the stress changes modulated under the tidal force. Moreover, unlike the thermal infrared remote sensing data, the air temperature data provided by NCEP are not affected by clouds, so it has a clear advantage for monitoring the pre-earthquake temperature variation in cloudy areas.
|
|---|