Experimental and simulation study on evaporation characteristics of E85 impinging spray under DISI cold-start condition
The direct injection of ethanol-gasoline blended fuel into the engine cylinder near the top dead center (TDC) is evitable to suffer from the wall impingement due to more injection mass required to maintain the same air/fuel ratio with traditional fossil fuels. In this study, the evaporation characte...
Main Authors: | Run CHEN, Keiya NISHIDA, Xinyi ZHOU, Tie LI |
---|---|
Format: | Article |
Language: | English |
Published: |
Elsevier
2023-12-01
|
Series: | Applications in Energy and Combustion Science |
Subjects: | |
Online Access: | http://www.sciencedirect.com/science/article/pii/S2666352X23001139 |
Similar Items
-
Fuel temperature and injection pressure influence on the cold start GDI sprays
by: Kyungwon Lee, et al.
Published: (2023-12-01) -
Evaporating characteristics of diesel sprays under split-injection condition with a negative dwell time
by: Yu Jin, et al.
Published: (2021-12-01) -
Solar Evaporation System Using Spray Pipe Method
by: Muljani Srie, et al.
Published: (2022-01-01) -
Effects of ambient and injection conditions on local heat transfer of impinging flame and spray to chamber wall
by: Jaehoon JEONG, et al.
Published: (2020-11-01) -
Experiment and Simulation Investigation on the Characteristics of Diesel Spray Impingement Based on Droplet Impact Phenomenon
by: Yongfeng Liu, et al.
Published: (2018-03-01)