Effect of the injection pressure and orifice diameter on the spray characteristics of biodiesel

Effect of the injection pressure and orifice diameter on the spray characteristics of biodiesel

The purpose of this study was to analyze the influence of the injection pressure and orifice diameter on the spray characteristics of soybean biodiesel. The macroscopic spray characteristics of the spray tip penetration (STP) and spray cone angle (SCA) were tested with a high-speed camera system. Th...

Full description

Bibliographic Details
Main Authors:	Limin Geng, Yanjuan Wang, Yueying Wang, Huimei Li
Format:	Article
Language:	English
Published:	KeAi Communications Co., Ltd. 2020-06-01
Series:	Journal of Traffic and Transportation Engineering (English ed. Online)
Subjects:	Biodiesel Injection pressure Orifice diameter Spray characteristics Size distribution
Online Access:	http://www.sciencedirect.com/science/article/pii/S2095756418303015

Similar Items

Numerical simulation of the influence of fuel temperature and injection parameters on biodiesel spray characteristics
by: Limin Geng, et al.
Published: (2020-02-01)

Numerical analysis of spray characterization of blends of hydrous ethanol with diesel and biodiesel
by: Vardelli Shanthan, et al.
Published: (2024-03-01)

Energy Efficiency for Biodiesel Production by Combining Two Orifices in Hydrodynamic Cavitation Reactor
by: Mahlinda Mahlinda, et al.
Published: (2014-12-01)

Effect of Biodiesel/Diesel Blend and Temperature on 1-Cylinder Diesel Fuel Injection Pump Performance and Spray Pattern
by: Samsudin Anis, et al.
Published: (2018-12-01)

Combustion and spray breakup characteristics of biodiesel for cold start application
by: V.D. Chaudhari, et al.
Published: (2021-12-01)

Spray Behavior, Combustion, and Emission Characteristics of Jet Propellant-5 and Biodiesel Fuels with Multiple Split Injection Strategies
by: Hyun Min Baek, et al.
Published: (2022-03-01)

Experimental Studies of Fuel Injection in a Diesel Engine with an Inclined Injector
by: V. G. Kamaltdinov, et al.
Published: (2019-07-01)

An Experimental Study on the Macroscopic Spray Characteristics of Biodiesel and Diesel in a Constant Volume Chamber
by: Hongzhan Xie, et al.
Published: (2015-06-01)

Numerical and Experimental Spray Analysis of Castor and Jatropha Biodiesel under Non-Evaporating Conditions
by: Muteeb ul Haq, et al.
Published: (2022-10-01)

CFD-Based Investigation on Effects of Orifice Length–Diameter Ratio for the Design of Hydrostatic Thrust Bearings
by: Siyu Gao, et al.
Published: (2021-01-01)

Spray combustion on wasted cooking oil as biodiesel fuel /
by: 406210 Kang, Keng Seong, et al.
Published: (2007)

Experimental investigation of the combustion characteristics of Mahua oil biodiesel-diesel blend using a DI diesel engine modified with EGR and nozzle hole orifice diameter
by: M. Vijay Kumar, et al.
Published: (2018-09-01)

Experimental and CFD Analysis on the Effect of Various Cold Orifice Diameters and Inlet Pressure of a Vortex Tube
by: N. Bagre, et al.
Published: (2022-11-01)

Fuel injection performance and spray characteristic of high‐pressure common rail systems at low temperatures
by: Fukang Ma, et al.
Published: (2024-03-01)

Characteristics of the Multiple Injection Diesel Spray Employed Common Rail System
by: Zhiqiang ZHANG, et al.
Published: (2013-03-01)

Improvement of spray characteristics of injection nozzle for direct injection Diesel engine
by: Nobushige TAMAKI, et al.
Published: (2017-06-01)

Flow Equations for Free-Flowable Particle Fractions of Sorbitol for Direct Compression: An Exploratory Multiple Regression Analysis of Particle and Orifice Size Influence
by: Julia Marushka, et al.
Published: (2022-08-01)

An Experimental Study on the Injection Characteristics and the Macroscopic Spray Characteristics of Rapeseed Oil-Diesel Fuel Blends
by: Stasys Slavinskas
Published: (2023-05-01)

Liquid-Nitrogen Spray-Cooling Combined Effect of the Spray Height and Heat-Sink-Surface Diameter
by: Yangzi She, et al.
Published: (2022-07-01)

Numerical research of biodiesel spray coupled cavitation by different environmental simulations under high injection pressure
by: Zhijiang Ni, et al.
Published: (2023-03-01)

Comparative investigation on macroscopic and microscopic characteristics of impingement spray of gasoline and ethanol from a GDI injector under injection pressure up to 50 MPa
by: Xiang Li, et al.
Published: (2023-12-01)

Physical Properties and Spray Characteristics of Ultrasound-assisted Emulsion based on Ultra Low Sulphur Diesel and Biodiesel
by: Van Huong Dong, et al.
Published: (2019-04-01)

Characteristics of flow through orifice-meter
by: Mohamed Assran, et al.
Published: (2024-05-01)

Effects of inclination of nozzle holes for direct injection Diesel engine on spray characteristics
by: Nobushige TAMAKI, et al.
Published: (2017-03-01)

Macroscopic Spray Behavior of a Single-Hole Common Rail Diesel Injector Using Gasoline-Blended 5% Biodiesel
by: Sakda Thongchai, et al.
Published: (2020-05-01)

Numerical study of effect of post injection coupled with EGR on combustion and emission performances of CRDI engine fueled with biodiesel-ethanol blends
by: Limin Geng, et al.
Published: (2023-12-01)

An Experimental and Numerical Study on the Cavitation and Spray Characteristics of Micro-Orifice Injectors under Low-Pressure Conditions
by: Tzeng-Yuan Chen, et al.
Published: (2024-02-01)

Design of high-dispersion atomization nozzle for direct injection Diesel engine (Effects of shapes and measurement of nozzle holes of injection nozzle on spray and flow characteristics)
by: Nobushige TAMAKI, et al.
Published: (2015-04-01)

Effect of Particle Diameter on Primary Breakup of High-Pressure Diesel Spray Atomization: A Study Based on Numerical Simulations Using the Eulerian–Lagrangian Model
by: Yan Lei, et al.
Published: (2022-12-01)

Sensors Based Measurement Techniques of Fuel Injection and Ignition Characteristics of Diesel Sprays in DI Combustion System
by: S. Rehman
Published: (2016-09-01)

Temporal Evolution of Split-Injected Fuel Spray at Elevated Chamber Pressures
by: Gang Wu, et al.
Published: (2019-11-01)

MEASUREMENT OF TWO-PHASE GAS-LIQUID FLOW USING STANDARD AND SLOTTED ORIFICE
by: Barbara Tomaszewska-Wach, et al.
Published: (2019-12-01)

Study of Spray Behaviors to Correlate with Engine Performance and Emissions of a Diesel Engine Using Canola-Based Biodiesel
by: Saiful Bari, et al.
Published: (2022-02-01)

The Effect of Elliptical Diesel Nozzles on Spray Liquid-Phase Penetration under Evaporative Conditions
by: Bifeng Yin, et al.
Published: (2020-05-01)

Analysis of upper and lower nappe profiles of large orifice for the design of bottom and roof profiles of high head orifice spillway
by: Shafqat Hussain Bhatti, et al.
Published: (2024-03-01)

An unusual example of isolated double-orifice tricuspid valve
by: Ashish Sapre, et al.
Published: (2013-01-01)

COMPARATIVE ANALYSIS OF ATOMIZING SPRAY FROM DIESEL INJECTORS USING ALGAE AND BIODIESEL FUELS
by: Noor M. Jasim
Published: (2019-01-01)

Experimental Investigation on Spray Characteristics of Waste Cooking Oil Biodiesel/Diesel Blends at Different Injection Parameters
by: Medhat ElKelawy, et al.
Published: (2019-12-01)

Comprehensive Spray Characteristics of Water in Port Fuel Injection Injector
by: Jeonghyun Park, et al.
Published: (2020-01-01)

Studies on temporal and spatial variation characteristics of spray boundary in diesel spray (Effects of injection pressure on spray vortex formation)
by: Kakeru NANJO, et al.
Published: (2021-10-01)