Synergistic effects of ultrasonic vibration and isothermal treatment on the peritectic transformation and microstructure evolution of Cu–Sn alloy

Synergistic effects of ultrasonic vibration and isothermal treatment on the peritectic transformation and microstructure evolution of Cu–Sn alloy

To facilitate and even complete the peritectic transformation, the ultrasonic vibration (USV) and isothermal treatment were applied to the solidification process of Cu–70Sn alloy. It was found that the peritectic transformation was difficult to carry out due to the limited atomic diffusion under the...

Full description

Bibliographic Details
Main Authors:	Xiaogang Fang, Yeliang Zhu, Shulin Lv, Shusen Wu, Shifeng Luo, Siliang Yan, Yong Ma, Jiguang Liu, Youwen Yang, Yiqing Chen
Format:	Article
Language:	English
Published:	Elsevier 2024-03-01
Series:	Journal of Materials Research and Technology
Subjects:	Cu-Sn alloy Peritectic transformation Ultrasonic vibration Isothermal treatment Microstructure
Online Access:	http://www.sciencedirect.com/science/article/pii/S2238785424000966

Similar Items

Microstructure refinement of Sn一Sb Peritectic alloy by power ultrasonic
by: Haibo ZHANG, et al.
Published: (2004-08-01)

Microstructural properties and peritectic reactions in a binary Co–Sn alloy by means of scanning electron microscopy and atom probe tomography
by: Muna Khushaim, et al.
Published: (2020-01-01)

Control of peritectic phase content and its effect on properties of CuSn20P1 alloy by semi-solid rheological forming
by: Hao Zhang, et al.
Published: (2025-01-01)

Back-Diffusion In Crystal Growth. Peritectics
by: Wołczyński W.
Published: (2015-09-01)

A peritectic phase refines the microstructure and enhances Zn implants
by: Cijun Shuai, et al.
Published: (2020-05-01)

Microstructural Evolution and Mechanical Properties in Directionally Solidified Sn–10.2 Sb Peritectic Alloy at a Constant Temperature Gradient
by: Elif Yılmaz, et al.
Published: (2016-02-01)

Quantitative isothermal phase-field simulations of peritectic phase transformation in FeMn system
by: Celso Luiz Moraes Alves, et al.
Published: (2016-01-01)

Solidification sequence and as-cast microstructure of a model Pb-Bi-Sn alloy with quasi-peritectic reaction
by: Gang Liu, et al.
Published: (2019-11-01)

Growth Law For Peritectic Phases Formation In The Zinc Coating
by: Guzik E., et al.
Published: (2015-09-01)

Carbon content influence on the peritectic reaction path in stainless steels
by: J. Głownia, et al.
Published: (2013-01-01)

Hot Ductility Behavior of a Peritectic Steel during Continuous Casting
by: Mustafa Merih Arıkan
Published: (2015-06-01)

Grain refinement and abnormal peritectic solidification in WxNbTiZr high-entropy alloys
by: Z.D. Shen, et al.
Published: (2022-12-01)

The investigation of peritectic solidification of high nitrogen stainless steels by in-situ observation
by: Wang Tong, et al.
Published: (2024-12-01)

Effect of Magnesium Treatment on the Hot Ductility of Ti-Bearing Peritectic Steel
by: Tianpeng Qu, et al.
Published: (2020-09-01)

Cellular automaton simulation of peritectic solidification of a C-Mn steel
by: Su Bin, et al.
Published: (2012-08-01)

Solidification characteristics of Fe-Ni peritectic alloy thin strips under a near-rapid solidification condition
by: Chang-jiang Song, et al.
Published: (2015-05-01)

Multi-phase field simulation of multi-grain peritectic transition in multiple phase transformation
by: Li Feng, et al.
Published: (2020-09-01)

Phase-field simulation of peritectic steels solidification with transformation-induced elastic effect
by: Celso Luiz Moraes Alves, et al.
Published: (2020-05-01)

Austenite grain growth in tailored cooling rate experiment designed by numerical simulation for peritectic steel
by: Peng Lan, et al.
Published: (2024-11-01)

Element Distribution and Its Induced Peritectic Reaction during Solidification of Ti-Al-Nb Alloys
by: Xiangjun Xu, et al.
Published: (2021-08-01)

Ultrasonic-assisted soldering of Mg alloy joints using Cu-foam/Sn composite solder foils
by: Shiqin Li, et al.
Published: (2022-06-01)

Effect of Ultrasonic Power on the Microstructure and Properties of a Semi-Solid Slurry of SnSbCu11-6 Alloy
by: Lei Wang, et al.
Published: (2024-12-01)

Microstructure evolution and coarsening kinetics of semisolid CuSn10P1 alloy under short-time isothermal treatment
by: Yongkun Li, et al.
Published: (2021-01-01)

Experimental Investigation of the Ti-Nb-Sn Isothermal Section at 1173 K
by: Jianli Wang, et al.
Published: (2016-03-01)

Analysis of the causes and conditions for the formation of surface defects on hot‑rolled products from peritectic steel grades obtained under the conditions OJSC “BSW – Management Company of the Holding “BMC”
by: A. V. Tereshchenko, et al.
Published: (2021-09-01)

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs
by: Zhipeng Yuan, et al.
Published: (2024-08-01)

Ultrasonic-assisted electrodeposition of Cu-Sn-TiO2 nanocomposite coatings with enhanced antibacterial activity
by: Dmitry S. Kharitonov, et al.
Published: (2021-07-01)

FORMATION OF Cu2SnS3 AND Cu2SnSe3 THIN FILMS
by: Budanov Alexander V., et al.
Published: (2019-03-01)

Interface Growth and Void Formation in Sn/Cu and Sn0.7Cu/Cu Systems
by: Jieshi Chen, et al.
Published: (2018-12-01)

The Effect of Electromagnetic Stirring on the Microstructure Evolution of Cu-15%Co Alloy
by: Lin Zhang, et al.
Published: (2018-10-01)

Microstructure and mechanical performance of dissimilar material joints of 2024Al and SiO2 glass by ultrasonic assisted soldering with Cu interlayer
by: Haijun Li, et al.
Published: (2022-05-01)

Comparative study on the bonding property of laser and reflow soldered Sn-3.0Ag-0.5Cu/Ni–P microbumps after isothermal aging and multiple reflowing
by: Yang Wu, et al.
Published: (2024-03-01)

Structural and Optical Properties of SnS2:Cu Thin films prepared by chemical Spbay Pyrolysis
by: Baghdad Science Journal
Published: (2010-03-01)

Control of intermetallic compounds in Ultrasonic-Assisted Sn soldering of Mg/Al alloys
by: Yingzong Liu, et al.
Published: (2022-11-01)

Improvement on the mechanical properties of eutectic Sn58Bi alloy with porous Cu addition during isothermal aging
by: Yang Liu, et al.
Published: (2021-01-01)

Calorimetric study on Bi-Cu-Sn alloys
by: Romanowska Jolanta
Published: (2019-02-01)

Effects of temperature and strain rate on tensile properties of (Ag,Cu)-Sn intermetallic compounds: A molecular dynamics study
by: Md. Maruf Billah, et al.
Published: (2022-05-01)

Research of joining the SiC and Cu combination by use of SnTi solder filled with SiC nanoparticles and with active ultrasound assistance
by: Tomas Melus, et al.
Published: (2024-10-01)

Structure and properties of Sn-Cu lead-free solders in electronics packaging
by: Meng Zhao, et al.
Published: (2019-12-01)

Raman study of flash-lamp annealed aqueous Cu2ZnSnS4 nanocrystals
by: Yevhenii Havryliuk, et al.
Published: (2019-01-01)