| Summary: | An experimental investigation of hydrodynamics of gas-solid flow is carried out by engaging different designs of air distributor plates. An analysis of three different plates, i.e., perforated, 45° slotted and novel hybrid plate, revealed the difference in pressure drop and minimum fluidization velocities (U<sub>mf</sub>) for varying input operational variables. U<sub>mf</sub> is found to be lowest for perforated and highest for 45° slotted plate, whereas pressure drop is found to be highest for 45° slotted plate and lowest for novel hybrid distributor plate. The bubbles rise velocity ratio (U<sub>mf,b</sub>/U<sub>mf,f</sub>) is noticed minimum for 45° slotted plate due to relatively larger bubbles originating from the bigger slot openings and maximum for perforated distributor plate owing to smaller bubbles with dominant axial rise. Furthermore, the bed height rise ratio (h/L) is observed as a minimum for perforated distributor and maximum for 45° slotted plate due to larger bubbles through 45° slots rupturing the bed surface, causing more bed expansion. Furthermore, CFD analysis is also carried out to observe the insight flow dynamics using the distributor plates. The simulations use a two-fluid model (TFM) and K-Epsilon turbulence models. CFD model shows promising results in agreement with the experimental results. CFD results revealed that the lower portion enhanced lateral dispersion/mixing of solid particles due to 45° angular openings of an air inlet. In contrast, the perforated plate exhibited a straight upward motion of small air bubbles, causing no radial/lateral mixing. CFD results for the hybrid plate show the mixed axial as well as lateral mixing of solids by revealing velocity distribution; therefore, the novel hybrid plate is found to be an optimum distributor plate due to its lowest pressure drop, adequate U<sub>mf</sub>, intermediary bed height rise ratio and moderate bubble rise velocity ratio across the bed.
|
|---|