NONUNIFORMITY DEFORMATION DURING ONESIDED METAL FLEW TO A DIE IMPRESSION
The problem of appearing defects in the form of crack formation on some areas of forgings can be explained by considerable non-uniformity deformation occurred in these areas. To optimize solving the problem in we suggest the method of defining these possible destructive areas.
Main Authors: | A.Z. ZHURAVLEV, N.A. IVCHENKO, E.A. EFREMOVA, G.N. BACLAG, V.V. КUZNECOW, A.S. DUGINCEW |
---|---|
Format: | Article |
Language: | Russian |
Published: |
Don State Technical University
2018-08-01
|
Series: | Вестник Донского государственного технического университета |
Subjects: | |
Online Access: | https://vestnik.donstu.ru/jour/article/view/1326 |
Similar Items
-
NONUNIFORMITY DEFORMATION DURING ONESIDED METAL FLEW TO A DIE IMPRESSION
by: A.Z. ZHURAVLEV, et al.
Published: (2007-12-01) -
Calculation of clamping error when mounting a workpiece on fixture supports
by: Yury V Belousov
Published: (2018-12-01) -
Полуполярный GaN(11-22) на наноструктурированном Si(113): структура для снижения термических напряжений
by: Василий Николаевич Бессолов, et al.
Published: (2023-12-01) -
Numerical Simulation of Adiabatic Shear Bands Formation in Composites
by: N. A. Kudryashov, et al.
Published: (2016-06-01) -
Макроскопические пространственно-временные закономерности развития локализованной пластической деформации при растяжении Fe-Cr-Ni сплавов
by: Светлана Александровна Баранникова, et al.
Published: (2023-03-01)