Multistage converter with reduced switch voltage stress and diode current stress

Multistage converter with reduced switch voltage stress and diode current stress

Abstract The utilization of switched inductors, involving parallel charging and series discharging of inductors, is extensively embraced in diverse DC–DC converters for attaining high voltage gain; nevertheless, the stress on switch voltage and diode current escalates considerably with an increased...

Full description

Bibliographic Details
Main Authors:	M. S. Bhaskar, Umashankar Subramaniam, Dhafer Almakhles, Sivakumar Selvam, M. Muhibbullah
Format:	Article
Language:	English
Published:	Wiley 2024-04-01
Series:	IET Power Electronics
Subjects:	current stress DC–DC power convertors multistage power convertors switches voltage stress
Online Access:	https://doi.org/10.1049/pel2.12677

Similar Items

A non‐isolated single‐switch ultra‐high step‐up DC–DC converter with coupled inductor and low‐voltage stress on switch
by: Ali Nadermohammadi, et al.
Published: (2024-02-01)

A transformer‐less DC–DC converter with high voltage conversion ratio adopting inverting voltage lift cell
by: Ebrahim Babaei, et al.
Published: (2022-05-01)

Non‐isolated high step‐up DC–DC converter based on switched‐inductor switched‐capacitor network for photovoltaic application
by: Hossein Jalali Farahani, et al.
Published: (2023-02-01)

A novel high‐efficient step‐up converter with continuous input current, common ground, and minimum stress on semiconductors
by: Reza Asgarnia, et al.
Published: (2023-05-01)

A new transformer‐less step‐up DC–DC converter with high voltage gain and reduced voltage stress on switched‐capacitors and power switches for renewable energy source applications
by: Maysam Abbasi, et al.
Published: (2021-05-01)

Performance improvement of a zero‐voltage switching interleaved high step‐up DC–DC converter with low‐voltage stresses
by: Tohid Nouri
Published: (2023-08-01)

Very high step‐down coupled inductor two‐phase buck converter with single magnetic element and inherent clamp voltage capability
by: Ahmad Ghamsari Esfahani, et al.
Published: (2024-04-01)

An interleaved high step‐up DC–DC converter based on coupled‐inductor
by: Kamran Karimi, et al.
Published: (2024-02-01)

An interleaved high step‐down coupled inductor based quadratic DC‐DC converter
by: Reza Pashaie, et al.
Published: (2023-07-01)

A capacitor voltage self‐balancing method of modular multilevel converters based on switching state matrix construction
by: Zhou Yiyuan, et al.
Published: (2023-05-01)

Fully soft switched high step‐up/down bidirectional buck/boost converter with reduced switch voltage stress
by: Mohsen Packnezhad, et al.
Published: (2023-05-01)

A new soft‐switching high gain DC/DC converter with bipolar outputs
by: Sara Hasanpour, et al.
Published: (2024-01-01)

Depth comparison of common inductor and common capacitor passive current sharing methods for multiphase LLC converter
by: Zhifeng Sun, et al.
Published: (2023-11-01)

An interleaved non‐isolated high gain soft switching DC–DC converter with small input current ripple
by: Sohrab Abbasian, et al.
Published: (2023-04-01)

A novel bidirectional DC–DC converter with high voltage conversion ratio and capability of cancelling input current ripple
by: Kazem Farajzadeh, et al.
Published: (2024-02-01)

Comprehensive review of nonisolated bridgeless power factor converter topologies
by: Ankit Kumar Singh, et al.
Published: (2021-05-01)

Stability enhancement of bi‐directional voltage source converters in modern power systems
by: Mohamad Amin Ghasemi, et al.
Published: (2024-01-01)

Low‐voltage DC building distribution and utilization system and its implementation in China southern grid
by: Peiqian Guo, et al.
Published: (2024-02-01)

Design, analysis, and implementation of a new high‐gain P‐type step‐up dc/dc converter with continuous input current and common ground
by: Alireza Lahooti Eshkevari, et al.
Published: (2021-01-01)

A new soft‐switching high step‐down DC‐DC converter for voltage regular module application
by: Mahmood Vesali, et al.
Published: (2022-03-01)

High voltage gain switched z‐source inverter with low current stress
by: Golaleh Zarei, et al.
Published: (2024-01-01)

A new modulation strategy on isolated battery charger with wide input and output voltage range
by: Hurng‐Liahng Jou, et al.
Published: (2023-06-01)

A non‐isolated DC‐DC converter with low voltage stress and high step‐down voltage conversion ratio
by: Stylianos P. Syrigos, et al.
Published: (2021-05-01)

A novel DC‐link voltage synchronous control with enhanced inertial capability for full‐scale power conversion wind turbine generators
by: Yao Qin, et al.
Published: (2024-03-01)

Ultra‐high gain quadratic boost DC–DC converter based on a three‐winding coupled inductor with reduced voltage stress for fuel cell‐based systems
by: Mostafa Karimi Hajiabadi, et al.
Published: (2023-12-01)

A new dual‐input high step‐up DC–DC converter with reduced switches stress and low input current ripple
by: Ataollah Samadian, et al.
Published: (2021-07-01)

Design and development of a cascaded modular multi‐level converter based on current‐fed quadruple‐active bridge converters for grid integration of photovoltaic systems
by: Zahra Malekjamshidi, et al.
Published: (2021-03-01)

Quasi‐fixed frequency controlled phase modulation LCC resonant converter with a wide power range
by: Ying Feng, et al.
Published: (2023-05-01)

A hybrid half‐bridge submodule‐based DC–DC modular multilevel converter with a single bidirectional high‐voltage valve
by: Ahmed Elserougi, et al.
Published: (2023-09-01)

Analysis and small‐signal modelling technique for support bus DC‐link of front‐end coupling inductance high step‐up single switch boost converter in low voltage renewable source
by: Anusak Bilsalam, et al.
Published: (2024-02-01)

A bidirectional high voltage ratio DC–DC topology for energy storage systems in microgrid
by: Mohamad Reza Banaei, et al.
Published: (2024-02-01)

New multilevel inverter based on reduced switch basic cell for high voltage levels
by: Ali Seifi, et al.
Published: (2024-03-01)

Current stress and switching loss evaluation of a unified expandable power converter used for grid‐integration of renewable energy sources
by: Hamed Bizhani, et al.
Published: (2021-09-01)

High step‐up quasi‐Z‐source converter with full soft switching range, continuous input current and low auxiliary elements
by: Maryam Hajilou, et al.
Published: (2023-08-01)

A selection principle of submodule switching state vectors for switching frequency reduction in voltage self‐balancing half‐bridge modular multilevel converters
by: Yiyuan Zhou, et al.
Published: (2024-01-01)

Comprehensive analysis and design of a switched‐inductor type low inductance‐requirement DC‐DC buck‐boost converter for low power applications
by: Hamood‐Ur‐Rehman, et al.
Published: (2023-05-01)

New transformer‐less DC–DC converter topologies with reduced voltage stress on capacitors and increased voltage conversion ratio
by: Maysam Abbasi, et al.
Published: (2021-05-01)

An improved time‐domain analytical method for LLC resonant converters and dead time designs for zero‐voltage switching
by: Jian Jiao, et al.
Published: (2023-07-01)

Investigation of a bidirectional DC/DC converter with zero‐voltage switching operation for battery interfaces
by: Veera Venkata Subrahmanya Kumar Bhajana, et al.
Published: (2021-02-01)

Equivalent converter method for analyzing complex DC–DC converting systems
by: Sagi Orel Moshe, et al.
Published: (2024-03-01)