| Summary: | Appearance quality is one of the most important indexes for many injection-molded products, like optical parts, automotive parts etc., especially at the area near the injection gate. Different from the work that focused on designing the dimensions of the runner, this work proposed a method which is based on the insert technology to improve the appearance quality of a standard automotive part. An insert was introduced into the runner system which located before the gate. Three different shapes of this insert (circular, rectangular and diamond) were used to study the effect of geometrical factors on the appearance quality in this paper. All inserts were parameterized to describe their location and dimensions. Based on the geometrical design parameters, expected improvement optimization problem about the appearance quality were solved by using sequential approximate optimization method. The appearance qualities of three cases are improved by 13.77%, 21.56%, 14.37% respectively. Results showed that the best geometrical design scheme of the insert is rectangular with the optimal geometrical location and dimensions. The reasons were discussed by investigating the flow and thermal history in detail. Compared with the design case without any insert, the heat was absorbed and the velocity field was changed by the insert before the polymer melts ran into the cavity. It changed the complicated thermo-mechanical history inside the material during the entire processing history, which improved the final appearance quality of this auto part.
|
|---|