Design and optimization of unit production cost for AWJ process on machining hybrid natural fibre composite material
It is very difficult to handle composite material using cutting edge process. The surface defects, fibre – matrix delamination, fibre pullouts and bulk material removal are some of the common effects while machining composite material. To reduce such machining effects, an advanced machining processe...
Main Authors: | S.P. Jani, A. Senthil Kumar, M. Adam Khan, A. Sujin Jose |
---|---|
Format: | Article |
Language: | English |
Published: |
KeAi Communications Co., Ltd.
2021-12-01
|
Series: | International Journal of Lightweight Materials and Manufacture |
Subjects: | |
Online Access: | http://www.sciencedirect.com/science/article/pii/S2588840421000354 |
Similar Items
-
Concise review on the mechanical characteristics of hybrid natural fibres with filler content
by: Timothy K. Mulenga, et al.
Published: (2020-10-01) -
Notes on the Abrasive Water Jet (AWJ) Machining
by: Lucie Gembalová, et al.
Published: (2021-11-01) -
Abrasive Waterjet (AWJ) Forces—Potential Indicators of Machining Quality
by: Libor M. Hlaváč, et al.
Published: (2021-06-01) -
Influence of Material Structure on Forces Measured during Abrasive Waterjet (AWJ) Machining
by: Libor M. Hlaváč, et al.
Published: (2020-09-01) -
Effect of Coconut Fillers on Hybrid Coconut Kevlar Fiber Reinforced Epoxy Composites
by: S. P. Jani, et al.
Published: (2015-12-01)