| Summary: | Developing an efficient photocathode system from earth abundant materials is essential for effectual Photoelectrochemical (PEC) water splitting. Charge transfer between heterojunctions is important in fabricating a novel photocathode, keeping cost-effectiveness, abundance, and PEC performance in mind. The p-type narrow band gap photocathode, CuO (Eg = 1.5 eV) synthesized by hydrothermal method, was decorated with Sb2S3 Nanospheres (NSs) by adopting a facile chemical bath deposition (CBD) procedure to fabricate CuO/Sb2S3 NSs heterojunction. Fabricated heterojunction showed better PEC performance contrary to bare CuO, improvement in photocurrent density CuO/Sb2S3 NSs (J = −1 mA cm−2) than CuO (J = −0.3 mA cm−2) photoelectrode at 0 VRHE in 0.5 M Na2SO4 (pH 6.85) is due to enhanced charge carrier generation/separation. The photostability of CuO/Sb2S3 remains intact for 2.5 h with no degradation in photocurrent density. Sb2S3 works as a sensitizer, diminishing the recombination rate of the e−/h+ in CuO/Sb2S3 NSs. UV–Visible and photoluminescence(PL) emission spectra results suggested CuO/Sb2S3 enhanced absorption spectrum and reduced rate of recombination. Electrochemical impedance spectroscopy studies show less charge transfer resistance for CuO/Sb2S3 NSs than CuO. This finding will pave new path in developing novel photocathodic material configurations and heterojunction with Cu-based binary oxides/chalcogenides for solar harvesting.
|
|---|