| Summary: | Aluminum slag waste generated from the smelting process of bauxite was used to prepare roof tiles samples. Clay was substituted by slag waste in percentages reaching 40% in the basic mix and the plasticity of the obtained mud was determined. This was followed by pressing the mud in steel molds and drying. The effect of waste addition on drying shrinkage was subsequently assessed. Firing of the green bodies was carried out at three temperatures (900, 1000 and 1100 °C) and hour soaking at each temperature. Fired roof tile properties improved on increasing the percentage of alumina sludge and firing temperature possibly because of the presence of high amounts of fluxing oxides in aluminum slag. This caused a drop in porosity that increased the mechanical strength of tiles. The results showed that the substitution of clay by 40% waste and firing at 1100 °C resulted in products conforming to ASTM C-1167 for clay type roof tiles. Cold water absorption dropped to 12%, below the maximum permissible limit of 15%, the value of Saturation Coefficient was 0.83, below the 0.86 limit and the obtained breaking strength of 3370N significantly exceeded the minimum requirement of 890N.
|
|---|