VARIATION OF MAIN PARAMETERS OF THE OPERATION OF THE RECIPROCATING ENGINE ACCORDING TO SPEED PERFORMANCES

VARIATION OF MAIN PARAMETERS OF THE OPERATION OF THE RECIPROCATING ENGINE ACCORDING TO SPEED PERFORMANCES

Comformity of changing of main parameters at operation of the reciprocating engine with air spool diffuser on two apeed performances was investigated.

Bibliographic Details
Main Authors:	Voronkov, A., Nikitchenko, I., Teslenko, Ye., Minin, A.
Format:	Article
Language:	English
Published:	Kharkiv National Automobile and Highway University 2012-06-01
Series:	Avtomobilʹnyj Transport (Harʹkov)
Subjects:	piston pneumatic engine speed parameters torque effective power air consumption
Online Access:	http://dspace.khadi.kharkov.ua/dspace/bitstream/123456789/655/1/AT_31_10.pdf

Similar Items

ON CHOOSING RATIONAL SET PARAMETERS OF THE PISTON PNEUMATIC ENGINE WITH VALVE AIR-DISTRIBUTION PERFORMANCE
by: F. Abramchuk, et al.
Published: (2010-12-01)

CHANGE ON SPEED AIR CHARACTERISTICS THE POWER INDICATOR INDEXES OF PNEUMATIC ENGINE WITHOUT HEATING THE CHARGE DURING THE ADMITTANCE
by: A. Voronkov
Published: (2014-10-01)

COMPUTATIONAL AND EXPERIMENTAL DETERMINATION OF ENERGY LOSS OF THE OPERATING FLUID IN THE INTAKE SYSTEM OF THE AUTOMOBILE PISTON PNEUMATIC ENGINE USING THE EXERGY METHOD
by: A. Voronkov, et al.
Published: (2018-11-01)

Pengaruh Variasi Diameter Torak terhadap Performansi Sepeda Motor Bertransmisi Manual
by: I Gede Billy Arya Pratama, et al.
Published: (2023-11-01)

GEOMETRY DEFINITION OF SPOOL VALVE WINDOWS OF THE PNEUMATIC ENGINE
by: А. Voronkov, et al.
Published: (2014-02-01)

Impact Characteristics of a Bidirectional Pneumatic DTH Hammer for Unconsolidated Formations
by: Yuanling Shi, et al.
Published: (2023-10-01)

STUDY OF ELABORATION OF CONSTRUCTION CRANKSHAFT PISTON OF AUTOMOBILE PNEUMATIC ENGINE
by: Voronkov, А.
Published: (2013-01-01)

Innovative Solution of Torsional Vibration Reduction by Application of Pneumatic Tuner in Shipping Piston Devices
by: Robert Grega, et al.
Published: (2023-01-01)

Torque and Power Characteristics of Single Piston LPG-Fueled Engines on Variations of Ignition Timing
by: Bagiyo Condro Purnomo, et al.
Published: (2019-04-01)

Investigation of the Mechanical and Electromechanical Starting Characteristics of an Asynchronous Electric Drive of a Two-Piston Marine Compressor
by: Sergei G. Chernyi, et al.
Published: (2021-02-01)

Reduction of torque pulsation in ultralight helicopter transmission
by: Vitaly Dudnik
Published: (2024-03-01)

High‐Speed and Low‐Energy Actuation for Pneumatic Soft Robots with Internal Exhaust Air Recirculation
by: Miao Feng, et al.
Published: (2023-04-01)

Dimensions of housing for elastomer-energized plastic-faced hydraulic seals in reciprocating applications
by: 8096 British Standards Institution

STABILITY AND EVENNESS OF CRANKSHAFT ROTATION OF SIX-CYLINDER PNEUMATIC V-ENGINE WITH VALVE AIR-DISTRIBUTION
by: F. Abramchuk, et al.
Published: (2010-12-01)

Considerations over the floating speed of a particle in vacuum pneumatic conveying sytems in flour milling
by: Tanase Tanase
Published: (2016-06-01)

An Original System for Controlling the Speed of Movement of Pneumatic Drives in Rehabilitation Devices
by: Marta Izabela Żyłka, et al.
Published: (2023-02-01)

Service life of low-speed long-running stages of compressor units and possible ways of its increase
by: V. L. Yusha, et al.
Published: (2019-04-01)

Parametric Analysis of Gas Leakage in the Piston–Cylinder Clearance of Reciprocating Compressors
by: Vitor M. Braga, et al.
Published: (2022-12-01)

SEED METERING MECHANISMS AND TRACTOR-SEEDER FORWARD SPEED ON CORN AGRONOMIC COMPONENTS
by: Jorge W. Cortez, et al.
Published: (2020-02-01)

Research on characteristics of air gap of speed-regulation magnet coupler under condition of constant load
by: GUO Yongcun, et al.
Published: (2017-11-01)

CHANGE OF EFFECTIVE ENERGY INDEXES OF PNEUMATIC ENGINE OPERATION ASSERDING TO SPEED CHARACTERISTICS
by: A. Voronkov
Published: (2015-07-01)

Experimental Investigation of Oil Transport during Low Load to High Load Transient in Internal Combustion Engines
by: Mo Li, et al.
Published: (2023-02-01)

Selection of Diagnostic Symptoms and Injection Subsystems of Marine Reciprocating Internal Combustion Engines
by: Jan Monieta
Published: (2019-04-01)

A Hydraulic Axial Piston Pump Fault Diagnosis Based on Instantaneous Angular Speed under Non-Stationary Conditions
by: Jiamin Liu, et al.
Published: (2023-09-01)

Study on Matching Constant Speed Propeller for Piston Engine on MALE UAV
by: WEN Zhanyong, et al.
Published: (2020-10-01)

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct
by: Yu Fang, et al.
Published: (2021-11-01)

Research on the High Speed of Piston Pumps Based on Rapid Erecting of Launch Vehicles
by: Mengya Hu, et al.
Published: (2023-06-01)

Analysis of Compressed Air Energy Conversion Processes in a Rotary Piston Pneumatic Engine
by: Mytrofanov O., et al.
Published: (2021-03-01)

Speed control of an electromechanical integrated harmonic piezodrive system
by: Lizhong XU, et al.
Published: (2018-01-01)

Improvement of the Torque-Speed Performance and Drive Efficiency in an SRM Using an Optimal Torque Sharing Function
by: Wei Ye, et al.
Published: (2018-05-01)

Assessing Finite Control Set Model Predictive Speed Controlled PMSM Performance for Deployment in Electric Vehicles
by: Abhishek Murali, et al.
Published: (2021-03-01)

Sensorless Speed/Torque Control of DC Machine Using Artificial Neural Network Technique
by: Rakan K. Antar, et al.
Published: (2016-09-01)

Piston rings up to 200 mm diameter for reciprocating internal combustion engines
by: 8096 British Standards Institution

Piston rings up to 200 mm diameter for reciprocating internal combustion engines
by: 8096 British Standards Institution, et al.

Development of a Flexible Lightweight Hydraulic-Pneumatic Flywheel System for Wind Turbine Rotors
by: Laurence Alhrshy, et al.
Published: (2020-09-01)

Dynamic Modelling and Experimental Validation of a Pneumatic Radial Piston Motor
by: Kyle Grimaldi, et al.
Published: (2023-02-01)

High efficiency pneumatic systems compressors hydrodynamics and termodynamics process research / Didelio našumo pneumatinės sistemos kompresorių hidrodinaminių ir termodinaminių procesų tyrimas
by: Paulius Bogdevičius, et al.
Published: (2016-12-01)

Research on performances of speed regulating mechanism of mine-used permanent magnet speed regulator
by: WANG Lei, et al.
Published: (2018-07-01)

Test of a New Low-Speed Compressed Air Engine for Energy Recovery
by: Mariusz Rząsa, et al.
Published: (2021-02-01)

Speed in the air /
by: 301511 Wragg, David W.
Published: (1974)