Improvement of the Strength of Spot Welding Joint for Aluminum Plates Using Powders as Additive
This research is interest in increasing the strength of spot welding joint for thin commercial Aluminum by adding casting component to the welding zone in the form of powder. Those components are copper, manganese and magnesium which are added in a different percentages it appear that the strength o...
| Main Authors: | , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Unviversity of Technology- Iraq
2013-08-01
|
| Series: | Engineering and Technology Journal |
| Subjects: | |
| Online Access: | https://etj.uotechnology.edu.iq/article_83168_1044a30b57805c6242c1d1fda857d0ca.pdf |
| Summary: | This research is interest in increasing the strength of spot welding joint for thin commercial Aluminum by adding casting component to the welding zone in the form of powder. Those components are copper, manganese and magnesium which are added in a different percentages it appear that the strength of the spot welding has been improved by (14.5%) when adding(0.4 grams of magnesium),(0.1 grams of manganese ) and (0.4 gram of copper). The powder is added in the welding zone boundary after made a single hole with a depth of (0.375mm) and a diameter of (1mm) in the center of spot welding point. To increase the welding strength, five holes have been made with the same above dimensions through the welding zone boundary. The percentages of additive used after reparation the reduction of Aluminum powder. The value of shearing strength increase with a percentage of (27.3%) as comparing with those without additive. Also, heat treatment has been done, which gave a redaction in the strength of spot welding. It has been observed that the increase in the temperature of heat treatment result in decreasing in the spot strength. Welding and cooling environment have an effect on the strength of welded specimen. Hence, air welding environment gives a good welding strength. |
|---|---|
| ISSN: | 1681-6900 2412-0758 |