Research on the wear and miscrostructure of as crank shaft bearing coated with alloys of zn-10c and zn-20al-15c-5o
The experiment of this study consists of coating the 6LD400 Lombardini crankshaft bearing surface with zinc based on two alloys using atmospheric plasma spray. The microstructure of the coatings and matrix have been investigated by the Scanning Electron Microscopy (SEM) and Energy Dispersive Spectro...
Main Authors: | Hanbey Hazar, Omer Cihan |
---|---|
Format: | Article |
Language: | English |
Published: |
Editura Universităţii "Petru Maior"
2014-12-01
|
Series: | Scientific Bulletin of the ''Petru Maior" University of Tîrgu Mureș |
Subjects: | |
Online Access: | http://scientificbulletin.upm.ro/papers/2013-2/04_H_Hazar%20-%20Research.pdf |
Similar Items
-
Optimizing the Process of Arc-Spraying To Improve Wear Resistance of Crank Shaft
by: Asmaa Ali Hussein, et al.
Published: (2011-10-01) -
Improvement of tribological properties of bearings by laser processing of cast-iron shafts of heavy-duty diesel engines
by: Alisin Valery
Published: (2023-01-01) -
Investigation report on the manufacturing of bicycle cranks and chainswheels/
by: Lembaga Kemajuan Perindustrian Malaysia. Bahagian Kajian dan Perusahaan
Published: (1979) -
Optimization Design of RV Reducer Crankshaft Bearing
by: Jian Huang, et al.
Published: (2020-09-01) -
Method of Accelerated Testing of Crankshaft Shells of the Combustion Engine in the Operating Process
by: O. Grytsyuk, et al.
Published: (2019-12-01)