| Summary: | As a kind of sliding bearing, the gas bearing is widely used in high-speed rotating machinery. It realizes energy cleaning in the field of high-speed rotating machinery. In order to solve the problem of reducing the service life of gas bearings due to friction during startup and shutdown, we use micromachining technology to process groove textures with different groove widths on the surface of 0Cr17Ni7Al, a common material for gas bearings. A ball–disc friction contrast test is conducted under dry friction conditions with and without texture. The experiment shows that the lowest average friction coefficient of 0.8 mm texture is σ = 0.745. When the friction radius is 22.5 mm, the wear rate of 1.0 mm texture is the lowest at ω = 3.118 × <inline-formula><math xmlns="http://www.w3.org/1998/Math/MathML" display="inline"><semantics><mrow><msup><mrow><mn>10</mn></mrow><mrow><mo>−</mo><mn>4</mn></mrow></msup><mi>m</mi><msup><mi>m</mi><mn>3</mn></msup><mo>/</mo><mi>N</mi><mo>·</mo><mi>m</mi><mi>m</mi></mrow></semantics></math></inline-formula>. However, the maximum friction coefficient reached is σ = 0.898. Under the nanometer scale, the contact between friction pairs is fully analyzed. The influence mechanism of different groove widths, friction impacts and climbing heights on the friction and wear properties of the micromechanical groove texture on the surface of 0Cr17Ni7Al stainless steel is studied at the nano-fractal scale. The effects of different width grooves on the surface texture and tribological properties of the micromachine are studied.
|
|---|