Accuracy of five ground heat flux empirical simulation methods in the surface-energy-balance-based remote-sensing evapotranspiration models
<p>Based on the assessment from 230 flux site observations, intra-day and daytime ground heat flux (<span class="inline-formula"><i>G</i></span>) accounted for 19.2 % and 28.8 % of the corresponding net radiation, respectively. This indicates that <span cla...
| Main Author: | |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Copernicus Publications
2022-12-01
|
| Series: | Hydrology and Earth System Sciences |
| Online Access: | https://hess.copernicus.org/articles/26/6207/2022/hess-26-6207-2022.pdf |
| Summary: | <p>Based on the assessment from 230 flux site observations, intra-day and daytime ground heat flux (<span class="inline-formula"><i>G</i></span>) accounted for 19.2 % and 28.8 % of the
corresponding net radiation, respectively. This indicates that <span class="inline-formula"><i>G</i></span> plays an important role in remote-sensing (RS) energy-balance-based
evapotranspiration (ET) models. The <span class="inline-formula"><i>G</i></span> empirical estimation methods have been evaluated at many individual sites, while there have been relatively few
multi-site evaluation studies. The accuracy of the five empirical <span class="inline-formula"><i>G</i></span> simulation methods in the surface-energy-balance-based RS–ET models was
evaluated using half-hourly observations. The linear coefficient (LC) method and the two methods embedded with the normalized difference vegetation
index (NDVI) were able to accurately simulate a half-hourly <span class="inline-formula"><i>G</i></span> series at most sites. The mean and median Nash–Sutcliffe efficiency (NSE) values of
all sites were generally higher than 0.50 in each half-hour period. The accuracy of each method varied significantly at different sites and at
half-hour intervals. The highest accuracy was exhibited during 06:00–07:00 LST (all times hereafter are LST), followed by the period of
17:00–18:00. There were 92 % (<span class="inline-formula">211</span>/<span class="inline-formula">230</span>) sites with an NSE of the LC method greater than 0.50 at 06:30. It showed a slightly higher accuracy
during nighttime periods than during daytime periods. The lowest accuracy was observed during the period of 10:00–15:30. The sites with an NSE
exceeding 0.50 only accounted for 51 % (<span class="inline-formula">118</span>/<span class="inline-formula">230</span>) and 43 % (<span class="inline-formula">100</span>/<span class="inline-formula">230</span>) at 10:30 and 13:30, respectively. The accuracy of the model was
generally higher in Northern Hemisphere sites than in Southern Hemisphere sites. In general, the highest and lowest accuracies were observed at the
high- and low-latitude sites, respectively. The performance of the LC method and the methods embedded with NDVI were generally satisfactory at the
Eurasian and North American sites, with the NSE values of most sites exceeding 0.70. Conversely, it exhibited relatively poor performance at the
African, South American, and Oceanian sites, especially the African sites. Both the temporal and spatial distributions of the accuracy of the
<span class="inline-formula"><i>G</i></span> simulation were positively correlated with the correlation between <span class="inline-formula"><i>G</i></span> and the net radiation. Although the <span class="inline-formula"><i>G</i></span> simulation methods accurately
simulated the <span class="inline-formula"><i>G</i></span> series at most sites and time periods, their performance was poor at some sites and time periods. The application of RS
ET datasets covering these sites requires caution. Further improvement of <span class="inline-formula"><i>G</i></span> simulations at these sites and time periods is recommended for the RS
ET modelers. In addition, variable parameters are recommended in empirical methods of <span class="inline-formula"><i>G</i></span> simulation to improve accuracy. Instead of the <span class="inline-formula"><i>R</i><sub>n</sub></span>, finding
another variable that has a physical connection and strong correlation with <span class="inline-formula"><i>G</i></span> might be a more efficient solution for the improvement, since
the weak correlation between <span class="inline-formula"><i>G</i></span> and <span class="inline-formula"><i>R</i><sub>n</sub></span> is the main reason for the poor performance at these regions.</p> |
|---|---|
| ISSN: | 1027-5606 1607-7938 |