| Summary: | In This paper, a high power sub-nanosecond pulse transmitter for Ultra-wideband radar sensor is presented. The backbone of the generator is considered as a step recovery diode and unique pulse injected into the circuit, which gives rise to an ultra-wide band Gaussian pulse. The transistor driver and transmission line pulse forming the whole network are investigated in detail. The main purpose of this work is to transform a square waveform signal to a driving pulse with the timing and the amplitude parameters required by the SRD to form an output Gaussian pulse, and then into high monocycle pulses. In simulation aspect, an improved output response is required, in this way a new model of step recovery diode has been proposed as a sharpener circuit. This proposition was applied to increase the rise-time of the pulses. For a good range radar, a high amplitude pulse is indispensable, especially when it comes to penetrate thick lossy materiel. In order to overcome this challenge, a simple technique and useful solution is introduced to increase the output amplitude of the transmitter. This technique consists to connect the outputs of two identical pulse generators in parallel respecting the restrictions required. The pulse transmitter circuit is completely fabricated using micro-strip structure technology characteristics. Waveforms of the generated monocycle pulses over 10V in amplitude with 3.5 % in overshoot have been obtained. Good agreement has been achieved between measurement and simulation results.
|
|---|