| Summary: | Abstract In this study, ZrO2, TiO2, and Fe3O4 components were synthesized by co-precipitation, sol–gel, and co-precipitation methods, respectively. In addition, solid-state dispersion method was used for synthesizing of ZrO2/TiO2/Fe3O4 ternary nanocomposite. The ZrO2/TiO2/Fe3O4 nanocomposite was characterized by different techniques including XRD, EDX, SEM, BET, FTIR, XPS, EELS, and Photoluminescence (PL). The FTIR analysis of ZrO2/TiO2/Fe3O4 photocatalyst showed strong peaks in the range of 450 to 700 cm−1, which represent stretching vibrations of Zr–O, Ti–O, and Fe–O. The results of FTIR and XRD, XPS analyses and PL spectra confirmed that the solid-state dispersion method produced ZrO2/TiO2/Fe3O4 nanocomposites. The EELS analysis confirmed the pure samples of Fe3O4, TiO2 and ZrO2. The EDAX analysis showed that the Zr:Ti:Fe atomic ratio was 0.42:2.08:1.00. The specific surface area, pores volume and average pores size of the photocatalyst were obtained 280 m2/g, 0.92 cm3/g, and 42 nm respectively. Furthermore, the performance of ZrO2/TiO2/Fe3O4 nanocomposite was evaluated for naproxen removal using the response surface method (RSM). The four parameters such as NPX concentration, time, pH and catalyst concentration was investigated. The point of zero charge of the photocatalyst was 6. The maximum and minimum degradation of naproxen using photocatalyst were 100% (under conditions: NPX concentration = 10 mg/L, time = 90 min, pH = 3 and catalyst concentration = 0.5 g/L) and 66.10% respectively. The stability experiment revealed that the ternary nanocatalyst demonstrates a relatively higher photocatalytic activity after 7 recycles.
|
|---|