| Summary: | As advanced manufacturing technologies become increasingly mature in civil engineering, novel tubular sections, characterised by appealing architectural appearance and prominent structural efficiency, can be fabricated, with an example being semi-oval hollow section. The present paper reports an experimental and numerical investigation into the global buckling behaviour and resistances of austenitic stainless steel semi-oval hollow section beam-columns under combined compression and bending. An experimental programme was firstly performed on ten austenitic stainless steel semi-oval hollow section beam-column specimens and included initial geometric imperfection measurements and eccentric compression tests. The obtained test failure loads, load–mid-height lateral deflection curves and failure modes were fully reported. Following the experimental programme, a numerical modelling programme was conducted, including validation studies to validate developed finite element models against the test results and parametric studies to generate additional numerical data. Given that the existing European code and American specification do not cover the design of stainless steel semi-oval hollow section components, the applicability of the codified design interaction curves for austenitic stainless steel circular hollow section beam-columns to their semi-oval hollow section counterparts was evaluated based on the obtained test and numerical data. The European code was found to result in relatively accurate and consistent resistance predictions for austenitic stainless steel semi-oval hollow section beam-columns with Class 1 and 2 cross-sections, but the resistance predictions for those with Class 3 cross-sections were conservative and scattered. The American specification was shown to offer overall accurate and consistent resistance predictions, but some resistance predictions were marginally unsafe.
|
|---|