Microstructural response and strain hardening in deep cold rolled nickel-based superalloy for aerospace application

Microstructural response and strain hardening in deep cold rolled nickel-based superalloy for aerospace application

Fatigue crack resistance is a critical factor for the performance of aero-engine components. Deep cold rolling (DCR) is one promising surface enhancement technique, as it generates deep compressive residual stresses with the good surface finish. In this work, the influence of DCR process on the micr...

書目詳細資料
Main Authors:	Kumar, Dharmesh, Idapalapati, Sridhar, Wei, Wang
其他作者:	School of Mechanical and Aerospace Engineering
格式:	Journal Article
語言:	English
出版:	2018
主題:	DRNTU::Engineering::Aeronautical engineering Deep Cold Rolling Nickel-based Superalloys
在線閱讀:	https://hdl.handle.net/10356/88867 http://hdl.handle.net/10220/45988

相似書籍

Microstructural characteristics and strengthening mechanisms in a polycrystalline Ni-based superalloy under deep cold rolling
由: Kumar, Dharmesh, et al.
出版: (2020)

The effect of cold-rolling reduction on the microstructure and mechanical properties of fine-grain IN907 superalloy sheet
由: Seyed Sajjad Babaei Sangtabi, et al.
出版: (2025-03-01)

Influence of residual stress distribution and microstructural characteristics on fatigue failure mechanism in Ni-based Superalloy
由: Kumar, Dharmesh, et al.
出版: (2022)

Effect of surface mechanical treatments on the microstructure-property-performance of engineering alloys
由: Kumar, Dharmesh, et al.
出版: (2020)

Influence of heat treatment on the conductivity of nickel-based superalloys
由: Nagarajan, Balasubramanian, et al.
出版: (2018)

Microstructural Analysis on Grain Boundary of Boron– and Zirconium–Containing Wrought Nickel-Based Superalloys
由: Byungil Kang, et al.
出版: (2024-03-01)

Microstructure-mechanical property correlation in shot peened and vibro-peened Ni-based superalloy
由: Kumar, Dharmesh, et al.
出版: (2020)

Microstructure and γ′ phase evolution characteristics of novel nickel-based superalloy during compression
由: Jianmin Cui, et al.
出版: (2024-11-01)

Fatigue crack propagation in turbine disks of EI698 superalloy
由: A.A. Shanyavskiy
出版: (2013-03-01)

Fatigue crack propagation in turbine disks of EI698 superalloy
由: A.A. Shanyavskiy
出版: (2013-03-01)

Microstructure and susceptibility to hot tearing of K424 nickel-based superalloys for turbocharger turbine wheels
由: ZHAO Zhan, et al.
出版: (2016-10-01)

Severe plastic cold rolling effects in nickel–vanadium alloy: Microstructure, texture evolution and mechanical properties
由: Hongyan Wang, et al.
出版: (2024-11-01)

Microstructure evolution and anisotropy of nickel-based superalloy fabricated by LPBF
由: Mingchuan LI, et al.
出版: (2025-01-01)

Influence of cold metal transfer welding parameters on the welding hot crack of Mar-M247 nickel-based superalloy
由: Yue Liu, et al.
出版: (2024-05-01)

Microstructure and oxidation resistance of Pd+Zr and Pd+Hf co-doped aluminide coatings deposited on Mar-M247 nickel superalloy
由: Romanowska J., et al.
出版: (2023-01-01)

Enabling tailored microstructures by hybrid directed energy deposition processing of a nickel-based superalloy
由: Clemens Johannes Müller, et al.
出版: (2024-12-01)

Thermodynamic Study on Denitrification and TiN Precipitation in IN718 Nickel Base Superalloy Melt
由: Luo　Xiaoyu, Guo　Jing, Guo　HanJie, Li　Zeyou
出版: (2024-01-01)

Microstructure and mechanical properties of a novel nickel-based powder superalloy
由: MA Xiangdong, et al.
出版: (2023-10-01)

Effect of solution parameters on microstructures and mechanical properties of K439B nickel-based superalloy
由: ZHANG Leilei, et al.
出版: (2024-04-01)

Hot deformation behavior and microstructure evolution of a novel nickel-based powder metallurgy superalloy
由: Jinlong Yang, et al.
出版: (2023-11-01)

Effect of withdrawal rate on freckle formation of large-size directional solidified nickel-based superalloy blades
由: Yongjia Zhang, et al.
出版: (2024-05-01)

Creep fracture of a nickel base single crystal superalloy along [011] orientation
由: SHUI Li, et al.
出版: (2015-05-01)

Effect of interrupted cooling on microstructural evolution and microhardness of FGH97 nickel-based PM superalloy
由: Yun Zeng, et al.
出版: (2024-05-01)

Effect of thickness on microstructure of thin-walled nickel-based single-crystal superalloy castings
由: Hanyuan Xu, et al.
出版: (2024-03-01)

Synergistic effect of rhenium and tungsten in nickel-based model single crystal superalloys
由: Wei Tan, et al.
出版: (2025-03-01)

Mechanism of heterogeneous substrate stimulating growth for nickel-based single crystal superalloy
由: Binqiang Wang, et al.
出版: (2024-11-01)

Reverse design of nickel-based superalloys based on thermodynamic calculation and machine learning
由: ZHU Yaliang, et al.
出版: (2024-06-01)

Effect of microstructure evolution on tensile properties of novel nickel-based powder metallurgy superalloys during long-term aging
由: ZHANG Hao, et al.
出版: (2023-10-01)

Microstructure Evolution of Alloy 800H during Cold Rolling and Subsequent Annealing
由: Qingshan Dong, et al.
出版: (2024-06-01)

Study on Re effect on the mechanical behavior of nickel-based single crystal superalloy
由: Xiaowei Li, et al.
出版: (2024-11-01)

Influence of deformation degree at cold-rolling on the anneal hardening effect in sintered copper-based alloys
由: Nestorović Svetlana
出版: (2004-01-01)

The interaction between dynamic recrystallization and twinning during the hot compression in a novel nickel-based superalloy
由: Xingyun Fan, et al.
出版: (2025-03-01)

Effect of molybdenum on isothermal oxidation behavior of 4th generation nickel-based single crystal superalloys
由: Weiqi Li, et al.
出版: (2024-03-01)

Evolution of high-temperature hardness of multimodal γ′ nickel-based superalloy
由: Yang Zhang, et al.
出版: (2024-03-01)

Recrystallization behavior of a high γ′-fraction Ni-based single crystal superalloy induced by residual strain
由: Qi Wang, et al.
出版: (2024-08-01)

EXPERIMENTAL STUDY ON GREEN DRILLING NICKEL-BASE SUPERALLOY WITH CARBIDE BIT (MT)
由: LI Hui, et al.
出版: (2023-01-01)

Finite Element Analysis of Deformation Behavior of Wire Cold Flat Rolling
由: Abdul Kareem Flaih Hassan
出版: (2011-08-01)

Progress in research and applications of additively manufactured nickel-based superalloy in aero-engines and gas turbines
由: WU Yu, et al.
出版: (2024-02-01)

Effects of Cold Deformation and Heat Treatments on the Microstructure and Properties of Fe-15Cr-25Ni Superalloy Cold-Drawn Bars
由: Yunfei Zhang, et al.
出版: (2024-12-01)

Microstructure and mechanical properties of highly porous Hastelloy-X nickel superalloy produced by a space holder approach
由: Aleksandra Bętkowska, et al.
出版: (2025-01-01)