Prediction of burr formation in fabricating MEMS components by micro end milling
This paper discusses burr formation in micromilling of AISI 304 stainless steel. Chip load, cutting speed and the application of coolant were chosen as the milling parameters. Experiments were conducted using 500 µm diameter tungsten carbide end milling tool. Milling parameters and measured burr hei...
| Main Authors: | , , , |
|---|---|
| פורמט: | Article |
| שפה: | English |
| יצא לאור: |
Trans Tech Publications Ltd., Switzerland
2009
|
| נושאים: | |
| גישה מקוונת: | http://irep.iium.edu.my/1021/1/Prediction_of_Burr_formation_in_fabricating_MEMs_components_by_micro_end_miling.pdf |