Design and implementation of a smart mobile phone jammer

Design and implementation of a smart mobile phone jammer

Intelligent mobile phone jammer is a device used to jam unathorized cellular phone while permitting authorized cellular phone to operate and control the usage of mobile phone in specific environment.

Bibliographic Details
Main Authors:	Chebil, Jalel, Islam, Md. Rafiqul, Khan, Sheroz, Khalifa, Othman Omran, Ahmed, Musse Mohamud
Format:	Monograph
Language:	English
Published:	s.n 2012
Subjects:	TK7885 Computer engineering
Online Access:	http://irep.iium.edu.my/34109/1/EDW_B1002-356.pdf

Similar Items

Signal attenuation due to duststorms at KA band
by: Elabdin, Zain, et al.
Published: (2009)

Wireless and wired remote measrement unit design and applications
by: Khan, Sheroz, et al.
Published: (2004)

An oblique-matrix technique for data integrity assurance
by: Ghaeb, Jasin Abdullah, et al.
Published: (2009)

A high performance data integrity assurance based on the determinant technique
by: Ghaeb, J. A., et al.
Published: (2011)

Vision based road lane detection system for vehicles guidance
by: Khalifa, Othman Omran, et al.
Published: (2011)

Novel MEMS fully differential capacitive transducer design and analysis
by: Ya, Ma Li, et al.
Published: (2011)

Neural network classifier for hand motion detection from EMG signal
by: Ibrahimy, Muhammad Ibn, et al.
Published: (2011)

Toward strategic green ICT policy to eliminate environmental problems
by: Hameed, Shihab A., et al.
Published: (2011)

Design and analysis of a first-order sigma-delta analog-to-digital converter for MEMS resistive sensor
by: Ma, Li Ya, et al.
Published: (2010)

Multivariable transducer interfacing circuit for wireless monitoring of smart implants
by: Khan, Sheroz, et al.
Published: (2009)

A low-cost first-order sigma-delta converter design and analysis
by: Ya, Ma Li, et al.
Published: (2011)

Multi-stereo camera system to enhance the position accuracy of image-guided surgery markers
by: Elsamnah, Fahed, et al.
Published: (2014)

Intelligent auto tracking in 3D space by image processing
by: Al-Khateeb, Khalid A. Saeed, et al.
Published: (2009)

Design and fabrication of an intelligent irrigation control system
by: Algeeb, A., et al.
Published: (2010)

Independent component analysis for fetal heart rate detection using photosplethysmography
by: Harbawi, Malek M.A., et al.
Published: (2009)

Developing a finite difference time domain (fdtd) software for solving large electromagnetic problems
by: Islam, Md. Rafiqul
Published: (2012)

Design and simulation of an on-chip oversampling converter with a CMOS-MEMS differential capacitive sensor
by: Ma, Li Ya, et al.
Published: (2011)

Phonetically rich and balanced text and speech corpora for Arabic language
by: Abushariah, Mohammad Abd-Alrahman Mahmoud, et al.
Published: (2011)

Video compression techniques: an overview
by: Abomhara, Mohamed, et al.
Published: (2010)

An Investigation of Femtocell Network Synchronization
by: Hasan, Mohammad Kamrul, et al.
Published: (2011)

Design of multi-valued quaternary based analog-to-digital converter
by: Alam, A. H. M. Zahirul, et al.
Published: (2009)

Ultra-wide-band modulation (UWB) modulation techniques for signal extraction from biomedical implants
by: Khan, Sheroz
Published: (2012)

Simple and efficient multibiometric technique for subject recognition using multilead electrocardiogram signal
by: Sidek, Khairul Azami, et al.
Published: (2013)

Analysis of inductive powering harvesting circuit
by: Ma , Li Ya, et al.
Published: (2010)

Effect of frequency on fade slope based on rain attenuation data measured in Malaysia
by: Islam, Md. Rafiqul, et al.
Published: (2010)

An enhanced scheme for QoS in mobile IPv6 environment
by: Hussien, Loay F., et al.
Published: (2011)

Data mining in mobile ECG based biometric identification
by: Sidek, Khairul Azami, et al.
Published: (2014)

Handoff latency analysis of mobile IPv6 protocol variations
by: Haseeb, Shariq, et al.
Published: (2007)

Comparative performance analysis of mobile IPv6 protocols: special reference to simultaneous bindings
by: Haseeb, Shariq, et al.
Published: (2006)

RF oscillator implementation using integrated CMOS surface acoustic wave resonators
by: Nordin, Anis Nurashikin, et al.
Published: (2011)

Design and implementation of a 1GHz CMOS resonator utilizing surface acoustic wave
by: Nordin, Anis Nurashikin, et al.
Published: (2006)

CMOS design and implementation of sigma-delta analog-to-digital data converter suitable for MEMS devices
by: Nordin, Anis Nurashikin, et al.
Published: (2002)

Design of triple-band h slot patch antenna
by: Noori, Omar, et al.
Published: (2011)

Design, simulation and fabrication of piezoelectric micro generators for aero acoustic applications
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2011)

Performance evaluation of MEMS piezoelectric inertial energy generator
by: Md Ralib @ Md Raghib, Aliza 'Aini, et al.
Published: (2011)

A computer based simulator for Erbium-Doped Fiber Amplifier
by: Naji, Ahmed Wathik, et al.
Published: (2010)

Challenges of hidden data in the unused area two within executable files
by: Naji, Ahmed Wathik, et al.
Published: (2009)

Smart portable security system
by: Mohamad Isa, Mohamad Nabil Amiruddin, et al.
Published: (2020)

Optimization of ANPR algorithm on android mobile phone
by: Mutholib, Abdul, et al.
Published: (2013)

Novel simulation framework of three-dimensional skull bio-metric measurement
by: Hameed, Shihab A., et al.
Published: (2009)