Residual stress and subsurface damage in machined alumina and alumina/silicon carbide nanocomposite ceramics

Residual stress and subsurface damage in machined alumina and alumina/silicon carbide nanocomposite ceramics

We have used TEM and Hertzian indentation to study the interrelation between subsurface damage and residual stress introduced by grinding and diamond polishing surfaces of polycrystalline alumina and 5%SiC/alumina nanocomposites. In all cases a layer of high dislocation density was found near the su...

Descripció completa

Dades bibliogràfiques
Autors principals:	Wu, H, Roberts, S, Derby, B
Format:	Journal article
Idioma:	English
Publicat:	Elsevier 2001

Ítems similars

Residual stress determination and subsurface microstructure in ground and polished alumina/silicon carbide nanocomposites and monolithic alumina ceramics
per: Wu, H, et al.
Publicat: (2000)

Subsurface damage in alumina and alumina-silicon carbide nanocomposites
per: Tanner, B, et al.
Publicat: (2004)

Ductile deformation in alumina/silicon carbide nanocomposites
per: Wu, H, et al.
Publicat: (2010)

Sub-surface damage in ground and annealed alumina and alumina-silicon carbide nanocomposites
per: Tanner, B, et al.
Publicat: (2006)

Crack healing in an alumina/silicon carbide nanocomposite after grinding and annealing
per: Wu, H, et al.
Publicat: (2000)

Alumina/silicon carbide nanocomposites
per: Todd, R
Publicat: (2005)

Polishing behavior and surface quality of alumina and alumina/silicon carbide nanocomposites
per: Kara, H, et al.
Publicat: (2000)

Polishing and wear behaviour of sintered alumina-silicon carbide nanocomposites
per: Cock, A, et al.
Publicat: (2001)

Erosive wear of alumina/SiC nanocomposite ceramics
per: Lawrence, C, et al.
Publicat: (1999)

Effects of yttrium on the sintering and microstructure of alumina-silicon carbide "nanocomposites"
per: Cock, A, et al.
Publicat: (2005)

Subsurface damage analysis by TEM and 3D FIB crack mapping in alumina and alumina/5vol.%SiC nanocomposites
per: Wu, H, et al.
Publicat: (2003)

Residual stress distribution in a functionally graded alumina-silicon carbide material
per: Dancer, C, et al.
Publicat: (2012)

Residual stress distribution in a functionally graded alumina-silicon carbide material
per: Dancer, C, et al.
Publicat: (2012)

Thermal shock resistance of sintered alumina/silicon carbide nanocomposites evaluated by indentation techniques
per: Maensiri, S, et al.
Publicat: (2002)

Evaluation of the self-healing capacity of ceramics produced with alumina and silicon carbide
per: N. R. de Souza, et al.
Publicat: (2022-07-01)

Wear Behavior of Graphene-Reinforced Alumina–Silicon Carbide Whisker Nanocomposite
per: Anton Smirnov, et al.
Publicat: (2019-01-01)

Densification studies of silicon carbide-based ceramics with yttria, silica and alumina as sintering additives
per: J. Marchi, et al.
Publicat: (2001-10-01)

Effect of residual compressive surface stress on severe wear of alumina-silicon carbide two-layered composites
per: Dancer, C.E.J., et al.
Publicat: (2014)

The wet erosive wear of polycrystalline alumina with silicon carbide particulate inclusions
per: Twigg, P, et al.
Publicat: (1997)

Fluorescence microscopy investigation on residual stresses in alumina-based ceramics
per: Guo, S
Publicat: (2008)

Spark plasma sintering of alumina/yttria‐doped silicon carbide
per: Antonio Popolizio, et al.
Publicat: (2020-03-01)

Electrical and thermal conductivity of CNT/alumina‐nanocomposite ceramics
per: Christian Bechteler, et al.
Publicat: (2023-01-01)

Neutron diffraction measurements of residual stresses in alumina/SiC nanocomposites
per: Todd, R, et al.
Publicat: (1997)

Dielectric properties of ceramic composite materials based on alumina reinforced by titanium carbide
per: Ouhassan Youssef, et al.
Publicat: (2020-01-01)

The effect of acrylate on the properties and machinability of alumina ceramics
per: Kokunešoski Maja, et al.
Publicat: (2023-01-01)

Evaluation of polishing damage in alumina
per: Pape, I, et al.
Publicat: (2000)

Through-hole drilling characteristics of alumina ceramics using diamond-coated carbide drill
per: Masato OKADA, et al.
Publicat: (2024-01-01)

Indentation-induced crack interaction in alumina ceramics
per: Twigg, P, et al.
Publicat: (1996)

Alumina based nanocomposites by precipitation
per: Xu, C
Publicat: (2014)

Thermal stress induced microcracking in alumina-20% SiCp composites
per: Todd, R, et al.
Publicat: (2004)

Preparation and Characterization of Fibrous Alumina and Zirconia Toughened Alumina Ceramics with Gradient Porosity
per: Eszter Bódis, et al.
Publicat: (2022-11-01)

Alumina-based nanocomposite ceramic cutting tool materials toughened by graphene nanoplates
per: MENG Xiang-long, et al.
Publicat: (2019-01-01)

Preparation and characterization of α-alumina nanoparticles and α-alumina-based polypropylene nanocomposites
per: Mirjalili, Fatemeh
Publicat: (2010)

Sintering temperature-microstructure-property relationships of alumina matrix composites with silicon carbide and silica additives
per: Limpichaipanit Apichart, et al.
Publicat: (2017-07-01)

Biocompatibility Study of A Hydroxyapatite-Alumina and Silicon Carbide Composite Scaffold for Bone Tissue Engineering
per: Mohammad Saki, et al.
Publicat: (2009-01-01)

Effect of alumina and halloysite clay in silicone rubber nanocomposite on the electrical tree characteristics
per: Ismail, Mohd Hafiz
Publicat: (2016)

Synthesis and Research of Alumina Ceramics Properties
per: Evgeniy I. Frolov, et al.
Publicat: (2020-12-01)

Refractory Ceramics of Clay and Alumina Waste
per: Valmir José da Silva, et al.
Publicat: (2021-02-01)

Processing and characterization of alumina–mullite ceramics
per: Chaouki Sadik
Publicat: (2014-12-01)

Rheological Behavior of Alumina Ceramic Pastes
per: Belkham N.H., et al.
Publicat: (2009-12-01)