Erosion resistance of hot pressed Al2O3/SiC nanocomposites

Erosion resistance of hot pressed Al2O3/SiC nanocomposites

Bibliografski detalji
Glavni autori:	Lawrence, C, Wu, H, Franco, A, Roberts, S, Derby, B
Format:	Journal article
Izdano:	1998

Slični predmeti

Erosive wear of alumina/SiC nanocomposite ceramics
od: Lawrence, C, i dr.
Izdano: (1999)

The strength of Al2O3/SiC nanocomposites after grinding and annealing
od: Wu, H, i dr.
Izdano: (1998)

Wet erosion behaviour of low SiC alumina-SiC nanocomposites
od: Kara, H, i dr.
Izdano: (2002)

An indentation model for erosive wear in Al2O3/SiC nanocomposites
od: Shapiro, I, i dr.
Izdano: (2011)

Residual stress distributions around indentations and scratches in polycrystalline Al2O3 and Al2O3/SiC nanocomposites measured using fluorescence probes
od: Wu, H, i dr.
Izdano: (2008)

Mechanical properties of hot-pressed SiC-TiC composites
od: Kamil Kornaus, i dr.
Izdano: (2017-12-01)

Effect of La on microstructures and mechanical properties of Cu/Ti3SiC2/C nanocomposites sintered by vacuum hot-pressing and hot isostatic pressing
od: Lan Lv, i dr.
Izdano: (2020-01-01)

TEM characterization of hot-pressed ZrB2-SiC-AlN composites
od: Van-Huy Nguyen, i dr.
Izdano: (2020-12-01)

Pressureless sintering and elastic constants of Al2O3-SiC 'nanocomposites'
od: Anya, C, i dr.
Izdano: (1997)

Fabrication of laminated ZrC-SiC composite by vacuum hot-pressing sintering
od: Yuanyuan Li
Izdano: (2015-03-01)

Thermal shock of ground and polished alumina and Al(2)O(3)/SiC nanocomposites
od: Maensiri, S, i dr.
Izdano: (2002)

INSTRUMENTED INDENTATION OF Al2O3-SiC NANOCOMPOSITES
od: Csehova, E, i dr.
Izdano: (2011)

Subsurface deformation of machined Al2O3 and Al2O3/5vol%SiC nanocomposite.
od: Wu, H, i dr.
Izdano: (2001)

Direct Observation of Induced Graphene and SiC Strengthening in Al–Ni Alloy via the Hot Pressing Technique
od: Omayma A. Elkady, i dr.
Izdano: (2021-09-01)

Corrosion behaviour of Al/SiC and Al/Al2O3 nanocomposites
od: Tamer Samir Mahmoud, i dr.
Izdano: (2012-12-01)

Effects of Multi-Phase Reinforcements on Microstructures, Mechanical and Tribological Properties of Cu/Ti3SiC2/C/BN/GNPs Nanocomposites Sintered by Vacuum Hot-Pressing and Hot Isostatic Pressing
od: Zhenyi Shao, i dr.
Izdano: (2016-12-01)

Effect of SiC addition on the mechanical properties and wear behavior of Al-SiC nanocomposites produced by accumulative roll bonding
od: Wael S Hassanein, i dr.
Izdano: (2020-01-01)

ABOUT THERMO-POWER PARAMETERS OF COMPACTING AT HOT PRESSING OF ACTIVATED BY BLAST POWDERS SiC
od: G. G. Goranskij
Izdano: (2005-11-01)

Strain Rate Effect on the Ductile Brittle Transition in Grinding Hot Pressed SiC Ceramics
od: Pai Huang, i dr.
Izdano: (2020-05-01)

Numerical simulation of residual stresses in hot isostatic pressed SiC/GH4738 composites
od: Yanju Wang, i dr.
Izdano: (2020-11-01)

Low pressure plasma spraying of sol-gel Al2O3/SiC nanocomposite coatings
od: Jiansirisomboon, S, i dr.
Izdano: (2001)

Microstructure and Mechanical Properties of Al2O3-SiC Nanocomposites with 0.05% MgO and Different SiC Volume Fraction
od: Ali Reza Moradkhani, i dr.
Izdano: (2012-06-01)

Microstructure and mechanical properties of cubic zirconia (8YSZ)/SiC nanocomposites
od: Donzel, L, i dr.
Izdano: (2000)

Characterization of (Zr,Ti)B2-SiC composites obtained by hot press sintering of ZrB2-SiC-TiO2 powder mixtures
od: Rosa Maria da Rocha, i dr.
Izdano: (2024-12-01)

Melt Processing and Characterization of Al-SiC Nanocomposite, Al, and Mg Foam Materials
od: Ahmed M. Nabawy, i dr.
Izdano: (2016-05-01)

Performance limits of high voltage press-pack SiC IGBT and SiC MOSFET devices
od: Lubin Han, i dr.
Izdano: (2022-10-01)

The relationship between microstructure, fracture and abrasive wear in Al2O3/SiC nanocomposites and microcomposites containing 5 and 10% SiC
od: Limpichaipanit, A, i dr.
Izdano: (2009)

High Temperature Resistive Gas Sensors Based on ZnO/SiC Nanocomposites
od: Vadim Platonov, i dr.
Izdano: (2019-06-01)

High-temperature resistive gas sensors based on ZnO/SiC nanocomposites
od: Vadim B. Platonov, i dr.
Izdano: (2019-07-01)

Oxidation and erosion behaviour of SiC-HfC multilayered composite
od: Branko Matović, i dr.
Izdano: (2014-03-01)

Study of dielectric strength of (Blend SiC) nanocomposites
od: Jaafar K. Ch. Al-Suwaydawei, i dr.
Izdano: (2018-11-01)

The Investigation of Hot Workability of AA 6063/SiC Composites with Different SiC Particulate Volume Fraction
od: Totik, Y., i dr.
Izdano: (2002-08-01)

Indentation fracture toughness and surface flaw analysis of sintered alumina/SiC nanocomposites
od: Anya, C, i dr.
Izdano: (1996)

Dendrite Refinement and Improved Mechanical Properties of SiC/TiC/Al Hybrid Nanocomposites
od: Hui Xie, i dr.
Izdano: (2022-01-01)

Hardness and indentation load-size effect in Al2O3-SiC nanocomposites
od: Csehova, E, i dr.
Izdano: (2011)

Electron microscopy of crack/particle interactions in Al2O3/SiC nanocomposites
od: Jiao, S, i dr.
Izdano: (1997)

Effect of reinforcement volume fraction on the mechanical properties of the Al-SiC nanocomposite materials
od: Iqbal, AKM Asif, i dr.
Izdano: (2017)

A Novel Route for Development of Bulk Al/SiC Metal Matrix Nanocomposites
od: Payodhar Padhi, i dr.
Izdano: (2011-01-01)

Enhanced strength and ductility of Al-SiC nanocomposites synthesized by accumulative roll bonding
od: Adnan I. Khadir, i dr.
Izdano: (2020-01-01)

Simulation of mechanical properties of Al-SiC nanocomposite using molecular dynamics method
od: R. Esmaeili, i dr.
Izdano: (2013-12-01)