$Oxford HEXameter: laboratory high energy X-ray diffractometer for bulk residual stress analysis$

Oxford HEXameter: laboratory high energy X-ray diffractometer for bulk residual stress analysis

Zobrazit další vydání (1)

Diffraction of penetrating radiation such as neutrons or high energy X-rays provides a powerful non-destructive method for the evaluation of residual stresses in engineering components. In particular, strain scanning using synchrotron energy-dispersive X-ray diffraction has been shown to offer a fas...

Podrobná bibliografie
Hlavní autoři:	Korsunsky, A, Zhang, S, Dini, D, Vorster, W, Liu, J
Médium:	Journal article
Jazyk:	English
Vydáno:	Trans Tech Publications 2006
Témata:	Engineering & allied sciences

Podobné jednotky

Oxford HEXameter: Laboratory high energy X-ray diffractometer for bulk residual stress analysis
Autor: Korsunsky, A, a další
Vydáno: (2006)

Comparison of X-ray diffraction measurement of residual elastic strains: monochromatic beam and image plate versus white beam energy-dispersive analysis
Autor: Vorster, W, a další
Vydáno: (2007)

High energy white beam x-ray diffraction studies of residual strains in engineering components
Autor: Zhang, S, a další
Vydáno: (2008)

High energy synchrotron X-ray measurements of 2D residual stress states in metal matrix composites
Autor: Korsunsky, A, a další
Vydáno: (2000)

Residual stresses in an induction hardened gear tooth mapped by synchrotron X-ray diffraction
Autor: Korsunsky, A, a další
Vydáno: (2003)

Fast residual stress mapping using energy-dispersive synchrotron X-ray diffraction on station 16.3 at the SRS
Autor: Korsunsky, A, a další
Vydáno: (2002)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
Autor: Golshan, M, a další
Vydáno: (2005)

Residual stress in laser bent steel components
Autor: Topić, M, a další
Vydáno: (2006)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
Autor: Korsunsky, A, a další
Vydáno: (2007)

Advanced strain analysis by high energy synchrotron X-ray diffraction
Autor: Korsunsky, A, a další
Vydáno: (2002)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
Autor: Jun, T, a další
Vydáno: (2008)

Experimental/modelling study of residual stress in Al/SiCp bent bars by synchrotron XRD and slitting eigenstrain methods
Autor: Song, X, a další
Vydáno: (2008)

Inter-granular residual stresses in polycrystalline aggregates: finite element modelling and diffraction post-processing
Autor: Song, X, a další
Vydáno: (2008)

An analysis of residual stresses and strains in shot peening
Autor: Korsunsky, A
Vydáno: (1997)

Energy calibration and full-pattern refinement for strain analysis using energy-dispersive and monochromatic X-ray diffraction
Autor: Liu, J, a další
Vydáno: (2005)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
Autor: Hofmann, F, a další
Vydáno: (2010)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
Autor: Prakash, D, a další
Vydáno: (2008)

Plastic bending of a residually stressed beam
Autor: Korsunsky, A, a další
Vydáno: (1997)

Residual stresses around welds in nickel-based superalloys
Autor: Korsunsky, A, a další
Vydáno: (2004)

On the modelling of residual stresses due to surface peening using eigenstrain distributions
Autor: Korsunsky, A
Vydáno: (2005)

Evaluation of residual stresses and strains using the Eigenstrain Reconstruction Method
Autor: Jun, T, a další
Vydáno: (2010)

Residual stress reconstruction by variational eigenstrain procedures
Autor: Korsunsky, A, a další
Vydáno: (2006)

Variational determination of eigenstrain sources of residual stress
Autor: Korsunsky, A, a další
Vydáno: (2004)

A beam-bending eigenstrain analysis of residual elastic strains in multi-scan laser-formed steel samples
Autor: Korsunsky, A, a další
Vydáno: (2008)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
Autor: Salimon, A, a další
Vydáno: (2000)

Mapping two-dimensional state of strain using synchrotron x-ray diffraction
Autor: Korsunsky, A, a další
Vydáno: (1998)

Strain gradient polycrystal plasticity analysis: Fe modeling and synchrotron X-ray diffraction
Autor: Song, X, a další
Vydáno: (2010)

On the measurement and interpretation of residual stress at the micro-scale
Autor: Korsunsky, A, a další
Vydáno: (2010)

Focused ion beam ring drilling for residual stress evaluation
Autor: Korsunsky, A, a další
Vydáno: (2009)

Analysis of residual stresses around welds in a combustion casing
Autor: Song, X, a další
Vydáno: (2009)

Variational eigenstrain analysis of residual stresses in a welded plate
Autor: Korsunsky, A, a další
Vydáno: (2007)

Investigation of residual stress induced crack closure and its effects on fatigue in metal matrix composites
Autor: Korsunsky, A, a další
Vydáno: (1997)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
Autor: Zhang, S, a další
Vydáno: (2008)

Intergranular lattice misorientation mapping by synchrotron x-ray micro-beams: Laue vs energy-resolved Laue vs monochromatic reciprocal space analysis
Autor: Hofmann, F, a další
Vydáno: (2010)

Residual stresses in induction-hardened gear teeth mapped by neutron diffraction
Autor: Korsunsky, A, a další
Vydáno: (2002)

Residual stresses induced by foreign object damage on gas tubine blades: an experimental approach
Autor: Duo, P, a další
Vydáno: (2015)

Evaluation and analysis of residual stresses due to foreign object damage
Autor: Duó, P, a další
Vydáno: (2007)

Neutron diffraction measurement and finite element modelling of residual strains due to bath and spray quenching of AISI 316L stainless steel cylinders
Autor: Vorster, W, a další
Vydáno: (2008)

Polycrystal deformation analysis by high energy synchrotron X-ray diffraction on the I12 JEEP beamline at Diamond Light Source
Autor: Korsunsky, A, a další
Vydáno: (2010)

Residual stress analysis in shot peened and fretting fatigued samples by the eigenstrain method
Autor: Korsunsky, A, a další
Vydáno: (2006)