$Oxford HEXameter: laboratory high energy X-ray diffractometer for bulk residual stress analysis$

Oxford HEXameter: laboratory high energy X-ray diffractometer for bulk residual stress analysis

Show other versions (1)

Diffraction of penetrating radiation such as neutrons or high energy X-rays provides a powerful non-destructive method for the evaluation of residual stresses in engineering components. In particular, strain scanning using synchrotron energy-dispersive X-ray diffraction has been shown to offer a fas...

Bibliografske podrobnosti
Main Authors:	Korsunsky, A, Zhang, S, Dini, D, Vorster, W, Liu, J
Format:	Journal article
Jezik:	English
Izdano:	Trans Tech Publications 2006
Teme:	Engineering & allied sciences

Podobne knjige/članki

Oxford HEXameter: Laboratory high energy X-ray diffractometer for bulk residual stress analysis
od: Korsunsky, A, et al.
Izdano: (2006)

Comparison of X-ray diffraction measurement of residual elastic strains: monochromatic beam and image plate versus white beam energy-dispersive analysis
od: Vorster, W, et al.
Izdano: (2007)

High energy white beam x-ray diffraction studies of residual strains in engineering components
od: Zhang, S, et al.
Izdano: (2008)

High energy synchrotron X-ray measurements of 2D residual stress states in metal matrix composites
od: Korsunsky, A, et al.
Izdano: (2000)

Residual stresses in an induction hardened gear tooth mapped by synchrotron X-ray diffraction
od: Korsunsky, A, et al.
Izdano: (2003)

Fast residual stress mapping using energy-dispersive synchrotron X-ray diffraction on station 16.3 at the SRS
od: Korsunsky, A, et al.
Izdano: (2002)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
od: Golshan, M, et al.
Izdano: (2005)

Residual stress in laser bent steel components
od: Topić, M, et al.
Izdano: (2006)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
od: Korsunsky, A, et al.
Izdano: (2007)

Advanced strain analysis by high energy synchrotron X-ray diffraction
od: Korsunsky, A, et al.
Izdano: (2002)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
od: Jun, T, et al.
Izdano: (2008)

Experimental/modelling study of residual stress in Al/SiCp bent bars by synchrotron XRD and slitting eigenstrain methods
od: Song, X, et al.
Izdano: (2008)

Inter-granular residual stresses in polycrystalline aggregates: finite element modelling and diffraction post-processing
od: Song, X, et al.
Izdano: (2008)

An analysis of residual stresses and strains in shot peening
od: Korsunsky, A
Izdano: (1997)

Energy calibration and full-pattern refinement for strain analysis using energy-dispersive and monochromatic X-ray diffraction
od: Liu, J, et al.
Izdano: (2005)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
od: Hofmann, F, et al.
Izdano: (2010)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
od: Prakash, D, et al.
Izdano: (2008)

Plastic bending of a residually stressed beam
od: Korsunsky, A, et al.
Izdano: (1997)

Residual stresses around welds in nickel-based superalloys
od: Korsunsky, A, et al.
Izdano: (2004)

On the modelling of residual stresses due to surface peening using eigenstrain distributions
od: Korsunsky, A
Izdano: (2005)

Evaluation of residual stresses and strains using the Eigenstrain Reconstruction Method
od: Jun, T, et al.
Izdano: (2010)

Residual stress reconstruction by variational eigenstrain procedures
od: Korsunsky, A, et al.
Izdano: (2006)

Variational determination of eigenstrain sources of residual stress
od: Korsunsky, A, et al.
Izdano: (2004)

A beam-bending eigenstrain analysis of residual elastic strains in multi-scan laser-formed steel samples
od: Korsunsky, A, et al.
Izdano: (2008)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
od: Salimon, A, et al.
Izdano: (2000)

Mapping two-dimensional state of strain using synchrotron x-ray diffraction
od: Korsunsky, A, et al.
Izdano: (1998)

Strain gradient polycrystal plasticity analysis: Fe modeling and synchrotron X-ray diffraction
od: Song, X, et al.
Izdano: (2010)

On the measurement and interpretation of residual stress at the micro-scale
od: Korsunsky, A, et al.
Izdano: (2010)

Focused ion beam ring drilling for residual stress evaluation
od: Korsunsky, A, et al.
Izdano: (2009)

Analysis of residual stresses around welds in a combustion casing
od: Song, X, et al.
Izdano: (2009)

Variational eigenstrain analysis of residual stresses in a welded plate
od: Korsunsky, A, et al.
Izdano: (2007)

Investigation of residual stress induced crack closure and its effects on fatigue in metal matrix composites
od: Korsunsky, A, et al.
Izdano: (1997)

Intergranular lattice misorientation mapping by synchrotron x-ray micro-beams: Laue vs energy-resolved Laue vs monochromatic reciprocal space analysis
od: Hofmann, F, et al.
Izdano: (2010)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
od: Zhang, S, et al.
Izdano: (2008)

Residual stresses in induction-hardened gear teeth mapped by neutron diffraction
od: Korsunsky, A, et al.
Izdano: (2002)

Residual stresses induced by foreign object damage on gas tubine blades: an experimental approach
od: Duo, P, et al.
Izdano: (2015)

Evaluation and analysis of residual stresses due to foreign object damage
od: Duó, P, et al.
Izdano: (2007)

Neutron diffraction measurement and finite element modelling of residual strains due to bath and spray quenching of AISI 316L stainless steel cylinders
od: Vorster, W, et al.
Izdano: (2008)

Polycrystal deformation analysis by high energy synchrotron X-ray diffraction on the I12 JEEP beamline at Diamond Light Source
od: Korsunsky, A, et al.
Izdano: (2010)

Residual stress analysis in shot peened and fretting fatigued samples by the eigenstrain method
od: Korsunsky, A, et al.
Izdano: (2006)