An indentation model for erosive wear in Al2O3/SiC nanocomposites

An indentation model for erosive wear in Al2O3/SiC nanocomposites

The erosive wear resistance of Al2O3 has been shown to be improved by the addition of 5vol.% of sub-micron sized SiC particles to form a 'nanocomposite', in agreement with previous results. The erosive wear was measured directly, and also estimated by an indentation model consisting of clo...

Descripció completa

Dades bibliogràfiques
Autors principals:	Shapiro, I, Todd, R, Titchmarsh, J, Roberts, S
Format:	Journal article
Idioma:	English
Publicat:	2011

Ítems similars

INSTRUMENTED INDENTATION OF Al2O3-SiC NANOCOMPOSITES
per: Csehova, E, et al.
Publicat: (2011)

Erosive wear of alumina/SiC nanocomposite ceramics
per: Lawrence, C, et al.
Publicat: (1999)

Effects of Y2O3 additives and powder purity on the densification and grain boundary composition of Al2O3/SiC nanocomposites
per: Shapiro, I, et al.
Publicat: (2009)

Hardness and indentation load-size effect in Al2O3-SiC nanocomposites
per: Csehova, E, et al.
Publicat: (2011)

Wet erosion behaviour of low SiC alumina-SiC nanocomposites
per: Kara, H, et al.
Publicat: (2002)

Erosion resistance of hot pressed Al2O3/SiC nanocomposites
per: Lawrence, C, et al.
Publicat: (1998)

The relationship between microstructure, fracture and abrasive wear in Al2O3/SiC nanocomposites and microcomposites containing 5 and 10% SiC
per: Limpichaipanit, A, et al.
Publicat: (2009)

INDENTATION LOAD-SIZE EFFECT IN Al2O3-SIC NANOCOMPOSITES
per: Csehova, E, et al.
Publicat: (2010)

Indentation fracture toughness and surface flaw analysis of sintered alumina/SiC nanocomposites
per: Anya, C, et al.
Publicat: (1996)

Study and Analysis of Al2O3-SiC Nanocomposite Ceramics’ Fracture Toughness using Vickers Indenter
per: AliReza Moradkhani, et al.
Publicat: (2011-06-01)

Residual stress distributions around indentations and scratches in polycrystalline Al2O3 and Al2O3/SiC nanocomposites measured using fluorescence probes
per: Wu, H, et al.
Publicat: (2008)

Quantitative optical fluorescence microprobe measurements of stresses around indentations in Al2O3 and Al2O3/SiC nanocomposites: The influence of depth resolution and specimen translucency
per: Guo, S, et al.
Publicat: (2011)

Pressureless sintering and elastic constants of Al2O3-SiC 'nanocomposites'
per: Anya, C, et al.
Publicat: (1997)

Effect of SiC addition on the mechanical properties and wear behavior of Al-SiC nanocomposites produced by accumulative roll bonding
per: Wael S Hassanein, et al.
Publicat: (2020-01-01)

The strength of Al2O3/SiC nanocomposites after grinding and annealing
per: Wu, H, et al.
Publicat: (1998)

Nanohardness and wear behavior of Copper-SiC-CNTs nanocomposites
per: Mallikarjuna H.M., et al.
Publicat: (2020-01-01)

Thermal shock of ground and polished alumina and Al(2)O(3)/SiC nanocomposites
per: Maensiri, S, et al.
Publicat: (2002)

FE simulation of the indentation deformation of SiC modified vinylester composites in respect to their abrasive wear performance
Publicat: (2008-10-01)

Corrosion behaviour of Al/SiC and Al/Al2O3 nanocomposites
per: Tamer Samir Mahmoud, et al.
Publicat: (2012-12-01)

Relationship between wear rate, surface pullout and microstructure during abrasive wear of alumina and alumina/SiC nanocomposites
per: Ortiz-Merino, J, et al.
Publicat: (2005)

Thermal microstress measurements in Al2O3/SiC nanocomposites by Cr3+ fluorescence microscopy
per: Merino, J, et al.
Publicat: (2003)

Subsurface deformation of machined Al2O3 and Al2O3/5vol%SiC nanocomposite.
per: Wu, H, et al.
Publicat: (2001)

Experimental Investigation on Metallurgical and Mechanical Properties and Wear Behavior of Al5032/SiC Nanocomposites
per: S. A. Muhammed Abraar, et al.
Publicat: (2023-07-01)

Influence of processing on the microstructural development and flexure strength of Al2O3/SiC nanocomposites
per: Borsa, C, et al.
Publicat: (1997)

Study on Indentation Experiments and Mechanical Behavior of RB-SiC
per: Cheng Fan, et al.
Publicat: (2017-01-01)

Low pressure plasma spraying of sol-gel Al2O3/SiC nanocomposite coatings
per: Jiansirisomboon, S, et al.
Publicat: (2001)

Microstructure and Mechanical Properties of Al2O3-SiC Nanocomposites with 0.05% MgO and Different SiC Volume Fraction
per: Ali Reza Moradkhani, et al.
Publicat: (2012-06-01)

High resolution optical microprobe investigation of surface grinding stresses in Al2O3 and Al2O3/SiC nanocomposites
per: Guo, S, et al.
Publicat: (2011)

Effect of SiC Particulate on Glass Fibers Reinforced Polymer Composites in Erosive Wear Environment
per: R.H. Abdel-Rahim, et al.
Publicat: (2017-02-01)

Heterodefloculação no sistema Al2O3 - SiC Heterodeflocculation in the Al2O3 - SiC system
per: I. R. de Oliveira, et al.
Publicat: (1998-12-01)

Effect of the amount of SiC, number of strokes, and applied load on the reciprocating wear behavior of Al-SiC composites
per: Lakshmipathy Jayakumar, et al.
Publicat: (2015-09-01)

Electron microscopy of crack/particle interactions in Al2O3/SiC nanocomposites
per: Jiao, S, et al.
Publicat: (1997)

Effect of Al2O3 and SiC Nano Reinforcements on Microstructure, Mechanical and Wear Properties of Surface Nanocomposites Fabricated by Friction Stir Processing
per: Naresh PARUMANDLA, et al.
Publicat: (2018-08-01)

Observation and simulation of indentation damage in a SiC-SiCfibre ceramic matrix composite
per: Saucedo-Mora, L, et al.
Publicat: (2015)

An Investigation of Abrasive Wear Behaviour of Al 2014-SiC Composites
per: Çalin Recep, et al.
Publicat: (2015-04-01)

Low pressure plasma-sprayed Al(2)O(3) and Al(2)O(3)/SiC nanocomposite coatings from different feedstock powders
per: Jiansirisomboon, S, et al.
Publicat: (2003)

PROCESSING AND PROPERTIES OF AL2O3/SIC NANOCOMPOSITES
per: Borsa, C, et al.
Publicat: (1995)

An Experimental Investigation into Wear Resistance of Mg-SiC Nanocomposite Produced at High Rate of Compaction
per: G.H. Majzoobi, et al.
Publicat: (2018-09-01)

Effect of SiC Particulate on Short Glass Fiber Reinforced Polyester Composite in Erosive Wear Environment
per: Ritesh KAUNDAL, et al.
Publicat: (2012-02-01)

The use of closely spaced vickers indentations to model erosion of polycrystalline α-Al2O3
per: Franco, A, et al.
Publicat: (2005)