The Oxford High Density Tunnel

The Oxford High Density Tunnel

This paper summarises the design, operation and installation of the High Density Tunnel at The University of Oxford. Developed in the early 1960’s, the facility has been used in various operating modes throughout its life. Acquired from Qinetiq in 2012, the facilty has been refurbished and is curren...

Full description

Bibliographic Details
Main Authors:	McGilvray, M, Doherty, L, Neely, A, Ireland, P, Pearce, R
Format:	Conference item
Published:	ESA Conference Bureau 2015

Similar Items

Thermal-fluid-structural analysis of the Oxford High Density Tunnel
by: Neely, A, et al.
Published: (2014)

Refurbishment and characterisation of the Oxford Low Density Hypersonic Wind Tunnel
by: Donaldson, N, et al.
Published: (2019)

Commissioning of the Oxford High Density Tunnel (HDT) for boundary layer stability measurements at Mach 7
by: Wylie, S, et al.
Published: (2018)

Commissioning Ludwieg mode with isentropic compression heating for the Oxford High Density Tunnel
by: Ivison, W, et al.
Published: (2024)

T6: The Oxford University Stalker tunnel
by: McGilvray, M, et al.
Published: (2015)

T6: The Oxford University Stalker Tunnel
by: McGilvray, M, et al.
Published: (2015)

Condition development and commissioning of the Oxford T6 Stalker Tunnel in reflected shock tunnel mode
by: Subiah, S, et al.
Published: (2019)

Experimental investigation of boundary layer instabilities and transition on sharp and blunt cones in Oxford’s High-Density Tunnel
by: Ceruzzi, AP, et al.
Published: (2024)

The Oxford T6 Stalker tunnel: performance, upgrades and new modes of operation
by: McGilvray, M, et al.
Published: (2022)

CONDITION DEVELOPMENT AND COMMISSIONING OF THE OXFORD T6 STALKER TUNNEL IN REFLECTED SHOCK TUNNEL MODE - Dataset
by: Hermann, T, et al.
Published: (2022)

Extension of test time in Ludwieg tunnels
by: Hillyer, J, et al.
Published: (2022)

Enhancing the test time performance of Ludwieg tunnels
by: Hillyer, J, et al.
Published: (2024)

Computational study of the effect of inlet velocity profile and rib orientation on heat transfer in rotating ribbed radial turbine cooling passages
by: Pearce, R, et al.
Published: (2016)

The Oxford Cold Driven Shock Tube (CDST) for fuel spray and chemical kinetics research
by: Camm, J, et al.
Published: (2018)

Commissioning of the T6 Stalker Tunnel
by: Collen, P, et al.
Published: (2019)

Computational and experimental study of heat transfer in rotating ribbed radial turbine cooling passages
by: Pearce, R, et al.
Published: (2015)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
by: McGilvray, M, et al.
Published: (2013)

Modelling the complete operation of a free-piston shock tunnel for a low enthalpy condition
by: McGilvray, M, et al.
Published: (2013)

Measurements of radiating hypervelocity air shock layers in the T6 free-piston driven shock tube
by: Collen, P, et al.
Published: (2019)

Performance capability experiments in T6: A hypervelocity, transient and multi-mode ground test facility for high-enthalpy aerothermodynamics research
by: Collen, P, et al.
Published: (2019)

Shock radiation tests for Ice Giant entry probes including CH4 in the T6 free-piston driven wind tunnel
by: Steer, J, et al.
Published: (2022)

Development and commissioning of the T6 Stalker Tunnel
by: Collen, P, et al.
Published: (2021)

Experimental simulation of a Galileo sub-scale model at Ice Giant entry conditions in the T6 free-piston driven wind tunnel
by: Steer, J, et al.
Published: (2022)

Free-flight aerodynamic testing of a 7 degree half-angle cone
by: Hyslop, A, et al.
Published: (2021)

Comparison of force measurement techniques in a short duration hypersonic facility
by: Hyslop, A, et al.
Published: (2024)

Stagnation point heat flux measurements in a plasma wind tunnel using a diamond heat transfer gauge
by: Penty Geraets, R, et al.
Published: (2019)

Aerodynamic testing of the Skylon spaceplane
by: Hyslop, A, et al.
Published: (2019)

Direct simulation of internal flow transient liquid crystal experiments
by: Forsyth, P, et al.
Published: (2018)

Numerical modelling techniques for turbine blade internal cooling passages
by: Dhopade, P, et al.
Published: (2015)

Free-flight aerodynamic testing of the Skylon space plane
by: Hyslop, A, et al.
Published: (2021)

Measurements of hypersonic double cone flows with shock wave/boundary layer interactions in the X3 expansion tunnel
by: Kennedy, A, et al.
Published: (2023)

Development of a novel mass flow measurement device for high speed inlet testing
by: Doherty, L, et al.
Published: (2019)

Mixing characteristics in a hypersonic flow around a transpiration cooled flat plate model
by: Hermann, T, et al.
Published: (2018)

Emission spectroscopy of low density air shock tube flows above 10 km/s
by: Hermann, T, et al.
Published: (2022)

Numerical Simulation of Transpiration Cooling for a High-Speed Vehicle with Substructure - Dataset
by: Naved, I, et al.
Published: (2022)

Analytical model of transpired-coolant concentration at downstream wall in high-speed laminar flow
by: Ifti, HS, et al.
Published: (2023)

Investigation of fluidic thrust vectoring for scramjets
by: Hambidge, C, et al.
Published: (2023)

Expansion tunnel radiation experiments to support hayabusa re-entry observations
by: Buttsworth, D, et al.
Published: (2010)

Absolute measurements of air shock-layer radiation in the T6 Aluminium Shock Tube
by: Collen, PL, et al.
Published: (2023)

Mixing Characteristics in a Hypersonic Flow around a Transpiration Cooled Flat Plate Model - Dataset
by: Hermann, T, et al.
Published: (2022)