Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Show other versions (1)

The objective of the present study is to review the different phenomena responsible for crack growth in the IN718 nickel-base superalloy under the combination of fatigue, creep and oxidation. We review the descriptions of the micro-mechanisms found in the literature, with a special emphasis on the t...

Fuld beskrivelse

Bibliografiske detaljer
Main Authors:	Prakash, D, Walsh, M, Maclachlan, D, Korsunsky, A
Andre forfattere:	European Structural Integrity Society
Format:	Journal article
Sprog:	English
Udgivet:	Elsevier 2009
Fag:	Engineering & allied sciences

Lignende værker

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation
af: Prakash, D, et al.
Udgivet: (2009)

Crack tip deformation fields and fatigue crack growth rates in Ti-6Al-4V
af: Korsunsky, A, et al.
Udgivet: (2009)

Investigation of residual stress induced crack closure and its effects on fatigue in metal matrix composites
af: Korsunsky, A, et al.
Udgivet: (1997)

Comparative assessment of dissipated energy and other fatigue criteria
af: Korsunsky, A, et al.
Udgivet: (2007)

Solution of axisymmetric crack problems using distributed dislocation ring dipoles
af: Korsunsky, A, et al.
Udgivet: (2000)

Size and scale effects in fretting fatigue thresholds
af: Dini, D, et al.
Udgivet: (2005)

The evolution of electrochemical, microstructural, and mechanical properties of aluminium alloy 2024-T4 (D16AT) during fatigue cycling
af: Salimon, S, et al.
Udgivet: (2010)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
af: Prakash, D, et al.
Udgivet: (2008)

Debonding of a weak interface in front of a through-thickness crack
af: Korsunsky, A
Udgivet: (2001)

The influence of coating cracking and debonding on the hardness of coated systems
af: Tuck, J, et al.
Udgivet: (2000)

An extension of the Dang Van fatigue criterion to finite life predictions
af: Korsunsky, A, et al.
Udgivet: (2009)

Microstructural Impact on Fatigue Crack Growth Behavior of Alloy 718
af: Christian Gruber, et al.
Udgivet: (2022-04-01)

Variational determination of the crack trajectory in inhomogeneous media
af: Miklashevich, I, et al.
Udgivet: (2001)

The relationship between the Dang Van criterion and the traditional bulk fatigue criteria
af: Peridas, G, et al.
Udgivet: (2003)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
af: Korsunsky, A, et al.
Udgivet: (2007)

Analysis of cohesive zones in cracks and slip bands using hypersingular interpolative quadratures
af: Korsunsky, A, et al.
Udgivet: (2000)

Vector J-integral analysis of crack initiation at the edge of complete sliding contact
af: Ma, L, et al.
Udgivet: (2006)

Vector J-integral analysis of crack interaction with pre-existing singularities
af: Ma, L, et al.
Udgivet: (2006)

Fundamental eigenstrain solutions for axisymmetric crack problems
af: Korsunsky, A
Udgivet: (1995)

Fatigue crack growth rate analysis in a titanium alloy
af: Korsunsky, A, et al.
Udgivet: (2008)

Effect of machined surface condition on fatigue strength of Ni based superalloy Alloy 718
af: Shota HASUNUMA, et al.
Udgivet: (2015-11-01)

Intergranular stresses in polycrystalline fatigue: diffraction measurement and self-consistent modelling
af: Korsunsky, A, et al.
Udgivet: (2003)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
af: Korsunsky, A
Udgivet: (2006)

Residual stress analysis in shot peened and fretting fatigued samples by the eigenstrain method
af: Korsunsky, A, et al.
Udgivet: (2006)

Neutron diffraction analysis of stresses in an in-plane biaxially-fatigued stainless steel sample of cruciform geometry
af: Taran, Y, et al.
Udgivet: (2008)

The correlation between plastic strain and anisotopy strain in aluminium alloy polycrystals
af: Korsunsky, A, et al.
Udgivet: (2002)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
af: Zhang, S, et al.
Udgivet: (2008)

On the micromechanics of micro-cantilever sensors: property analysis and eigenstrain modeling
af: Korsunsky, A, et al.
Udgivet: (2007)

On the measurement and interpretation of residual stress at the micro-scale
af: Korsunsky, A, et al.
Udgivet: (2010)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
af: Golshan, M, et al.
Udgivet: (2005)

Some aspects of crack initiation in mild steel subjected to fatigue stressing in a corrosive environment
af: Ray, G. P.
Udgivet: (1983)

The character of dislocation structure evolution in nanocrystalline FCC Ni-Co alloys prepared by high-energy mechanical milling
af: Salimon, A, et al.
Udgivet: (1999)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
af: Jun, T, et al.
Udgivet: (2008)

Neutron diffraction investigation of an in-plane biaxial fatigued stainless steel sample of cruciform geometry
af: Taran, Y, et al.
Udgivet: (2008)

Prediction of fatigue crack growth rates in Ti-6Al-4V alloy
af: Korsunsky, A, et al.
Udgivet: (2008)

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
af: Korsunsky, A, et al.
Udgivet: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
af: Tcherdyntsev, V, et al.
Udgivet: (2002)

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
af: Salimon, A, et al.
Udgivet: (2001)

The effect of wear on nucleation of cracks at the edge of an almost complete contact
af: Hills, D, et al.
Udgivet: (2010)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
af: Hofmann, F, et al.
Udgivet: (2010)