Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Hiển thị phiên bản (1) khác

The objective of the present study is to review the different phenomena responsible for crack growth in the IN718 nickel-base superalloy under the combination of fatigue, creep and oxidation. We review the descriptions of the micro-mechanisms found in the literature, with a special emphasis on the t...

Mô tả đầy đủ

Chi tiết về thư mục
Những tác giả chính:	Prakash, D, Walsh, M, Maclachlan, D, Korsunsky, A
Tác giả khác:	European Structural Integrity Society
Định dạng:	Journal article
Ngôn ngữ:	English
Được phát hành:	Elsevier 2009
Những chủ đề:	Engineering & allied sciences

Những quyển sách tương tự

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation
Bằng: Prakash, D, et al.
Được phát hành: (2009)

Crack tip deformation fields and fatigue crack growth rates in Ti-6Al-4V
Bằng: Korsunsky, A, et al.
Được phát hành: (2009)

Investigation of residual stress induced crack closure and its effects on fatigue in metal matrix composites
Bằng: Korsunsky, A, et al.
Được phát hành: (1997)

Comparative assessment of dissipated energy and other fatigue criteria
Bằng: Korsunsky, A, et al.
Được phát hành: (2007)

Solution of axisymmetric crack problems using distributed dislocation ring dipoles
Bằng: Korsunsky, A, et al.
Được phát hành: (2000)

Size and scale effects in fretting fatigue thresholds
Bằng: Dini, D, et al.
Được phát hành: (2005)

The evolution of electrochemical, microstructural, and mechanical properties of aluminium alloy 2024-T4 (D16AT) during fatigue cycling
Bằng: Salimon, S, et al.
Được phát hành: (2010)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
Bằng: Prakash, D, et al.
Được phát hành: (2008)

Debonding of a weak interface in front of a through-thickness crack
Bằng: Korsunsky, A
Được phát hành: (2001)

The influence of coating cracking and debonding on the hardness of coated systems
Bằng: Tuck, J, et al.
Được phát hành: (2000)

An extension of the Dang Van fatigue criterion to finite life predictions
Bằng: Korsunsky, A, et al.
Được phát hành: (2009)

Microstructural Impact on Fatigue Crack Growth Behavior of Alloy 718
Bằng: Christian Gruber, et al.
Được phát hành: (2022-04-01)

Variational determination of the crack trajectory in inhomogeneous media
Bằng: Miklashevich, I, et al.
Được phát hành: (2001)

The relationship between the Dang Van criterion and the traditional bulk fatigue criteria
Bằng: Peridas, G, et al.
Được phát hành: (2003)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
Bằng: Korsunsky, A, et al.
Được phát hành: (2007)

Analysis of cohesive zones in cracks and slip bands using hypersingular interpolative quadratures
Bằng: Korsunsky, A, et al.
Được phát hành: (2000)

Vector J-integral analysis of crack initiation at the edge of complete sliding contact
Bằng: Ma, L, et al.
Được phát hành: (2006)

Vector J-integral analysis of crack interaction with pre-existing singularities
Bằng: Ma, L, et al.
Được phát hành: (2006)

Fundamental eigenstrain solutions for axisymmetric crack problems
Bằng: Korsunsky, A
Được phát hành: (1995)

Fatigue crack growth rate analysis in a titanium alloy
Bằng: Korsunsky, A, et al.
Được phát hành: (2008)

Effect of machined surface condition on fatigue strength of Ni based superalloy Alloy 718
Bằng: Shota HASUNUMA, et al.
Được phát hành: (2015-11-01)

Intergranular stresses in polycrystalline fatigue: diffraction measurement and self-consistent modelling
Bằng: Korsunsky, A, et al.
Được phát hành: (2003)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
Bằng: Korsunsky, A
Được phát hành: (2006)

Residual stress analysis in shot peened and fretting fatigued samples by the eigenstrain method
Bằng: Korsunsky, A, et al.
Được phát hành: (2006)

Neutron diffraction analysis of stresses in an in-plane biaxially-fatigued stainless steel sample of cruciform geometry
Bằng: Taran, Y, et al.
Được phát hành: (2008)

The correlation between plastic strain and anisotopy strain in aluminium alloy polycrystals
Bằng: Korsunsky, A, et al.
Được phát hành: (2002)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
Bằng: Zhang, S, et al.
Được phát hành: (2008)

On the micromechanics of micro-cantilever sensors: property analysis and eigenstrain modeling
Bằng: Korsunsky, A, et al.
Được phát hành: (2007)

On the measurement and interpretation of residual stress at the micro-scale
Bằng: Korsunsky, A, et al.
Được phát hành: (2010)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
Bằng: Golshan, M, et al.
Được phát hành: (2005)

Some aspects of crack initiation in mild steel subjected to fatigue stressing in a corrosive environment
Bằng: Ray, G. P.
Được phát hành: (1983)

The character of dislocation structure evolution in nanocrystalline FCC Ni-Co alloys prepared by high-energy mechanical milling
Bằng: Salimon, A, et al.
Được phát hành: (1999)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
Bằng: Jun, T, et al.
Được phát hành: (2008)

Neutron diffraction investigation of an in-plane biaxial fatigued stainless steel sample of cruciform geometry
Bằng: Taran, Y, et al.
Được phát hành: (2008)

Prediction of fatigue crack growth rates in Ti-6Al-4V alloy
Bằng: Korsunsky, A, et al.
Được phát hành: (2008)

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
Bằng: Korsunsky, A, et al.
Được phát hành: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
Bằng: Tcherdyntsev, V, et al.
Được phát hành: (2002)

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
Bằng: Salimon, A, et al.
Được phát hành: (2001)

The effect of wear on nucleation of cracks at the edge of an almost complete contact
Bằng: Hills, D, et al.
Được phát hành: (2010)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
Bằng: Hofmann, F, et al.
Được phát hành: (2010)