Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation

Show other versions (1)

The objective of the present study is to review the different phenomena responsible for crack growth in the IN718 nickel-base superalloy under the combination of fatigue, creep and oxidation. We review the descriptions of the micro-mechanisms found in the literature, with a special emphasis on the t...

書目詳細資料
Main Authors:	Prakash, D, Walsh, M, Maclachlan, D, Korsunsky, A
其他作者:	European Structural Integrity Society
格式:	Journal article
語言:	English
出版:	Elsevier 2009
主題:	Engineering & allied sciences

相似書籍

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation
由: Prakash, D, et al.
出版: (2009)

Crack tip deformation fields and fatigue crack growth rates in Ti-6Al-4V
由: Korsunsky, A, et al.
出版: (2009)

Investigation of residual stress induced crack closure and its effects on fatigue in metal matrix composites
由: Korsunsky, A, et al.
出版: (1997)

Comparative assessment of dissipated energy and other fatigue criteria
由: Korsunsky, A, et al.
出版: (2007)

Solution of axisymmetric crack problems using distributed dislocation ring dipoles
由: Korsunsky, A, et al.
出版: (2000)

Size and scale effects in fretting fatigue thresholds
由: Dini, D, et al.
出版: (2005)

The evolution of electrochemical, microstructural, and mechanical properties of aluminium alloy 2024-T4 (D16AT) during fatigue cycling
由: Salimon, S, et al.
出版: (2010)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
由: Prakash, D, et al.
出版: (2008)

Debonding of a weak interface in front of a through-thickness crack
由: Korsunsky, A
出版: (2001)

The influence of coating cracking and debonding on the hardness of coated systems
由: Tuck, J, et al.
出版: (2000)

An extension of the Dang Van fatigue criterion to finite life predictions
由: Korsunsky, A, et al.
出版: (2009)

Microstructural Impact on Fatigue Crack Growth Behavior of Alloy 718
由: Christian Gruber, et al.
出版: (2022-04-01)

Variational determination of the crack trajectory in inhomogeneous media
由: Miklashevich, I, et al.
出版: (2001)

The relationship between the Dang Van criterion and the traditional bulk fatigue criteria
由: Peridas, G, et al.
出版: (2003)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
由: Korsunsky, A, et al.
出版: (2007)

Analysis of cohesive zones in cracks and slip bands using hypersingular interpolative quadratures
由: Korsunsky, A, et al.
出版: (2000)

Vector J-integral analysis of crack initiation at the edge of complete sliding contact
由: Ma, L, et al.
出版: (2006)

Vector J-integral analysis of crack interaction with pre-existing singularities
由: Ma, L, et al.
出版: (2006)

Fundamental eigenstrain solutions for axisymmetric crack problems
由: Korsunsky, A
出版: (1995)

Fatigue crack growth rate analysis in a titanium alloy
由: Korsunsky, A, et al.
出版: (2008)

Effect of machined surface condition on fatigue strength of Ni based superalloy Alloy 718
由: Shota HASUNUMA, et al.
出版: (2015-11-01)

Intergranular stresses in polycrystalline fatigue: diffraction measurement and self-consistent modelling
由: Korsunsky, A, et al.
出版: (2003)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
由: Korsunsky, A
出版: (2006)

Residual stress analysis in shot peened and fretting fatigued samples by the eigenstrain method
由: Korsunsky, A, et al.
出版: (2006)

Neutron diffraction analysis of stresses in an in-plane biaxially-fatigued stainless steel sample of cruciform geometry
由: Taran, Y, et al.
出版: (2008)

The correlation between plastic strain and anisotopy strain in aluminium alloy polycrystals
由: Korsunsky, A, et al.
出版: (2002)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
由: Zhang, S, et al.
出版: (2008)

On the micromechanics of micro-cantilever sensors: property analysis and eigenstrain modeling
由: Korsunsky, A, et al.
出版: (2007)

On the measurement and interpretation of residual stress at the micro-scale
由: Korsunsky, A, et al.
出版: (2010)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
由: Golshan, M, et al.
出版: (2005)

Some aspects of crack initiation in mild steel subjected to fatigue stressing in a corrosive environment
由: Ray, G. P.
出版: (1983)

The character of dislocation structure evolution in nanocrystalline FCC Ni-Co alloys prepared by high-energy mechanical milling
由: Salimon, A, et al.
出版: (1999)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
由: Jun, T, et al.
出版: (2008)

Neutron diffraction investigation of an in-plane biaxial fatigued stainless steel sample of cruciform geometry
由: Taran, Y, et al.
出版: (2008)

Prediction of fatigue crack growth rates in Ti-6Al-4V alloy
由: Korsunsky, A, et al.
出版: (2008)

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
由: Korsunsky, A, et al.
出版: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
由: Tcherdyntsev, V, et al.
出版: (2002)

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
由: Salimon, A, et al.
出版: (2001)

The effect of wear on nucleation of cracks at the edge of an almost complete contact
由: Hills, D, et al.
出版: (2010)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
由: Hofmann, F, et al.
出版: (2010)