Asymptotic analysis of the corner-behaviour of a rigid punch bonded to an elastic substrate

Asymptotic analysis of the corner-behaviour of a rigid punch bonded to an elastic substrate

Detalles Bibliográficos
Autores principales:	Bohrquez, L, Hills, D
Formato:	Journal article
Publicado:	2007

Ejemplares similares

THE SOLUTION OF THE CONTACT BETWEEN A TILTED CIRCULAR RIGID PUNCH AND AN ELASTIC HALF-SPACE
por: Munisamy, R, et al.
Publicado: (1995)

Contact of a rigid cylinder indenting an elastic layer sliding over a rigid substrate
por: Reina, S, et al.
Publicado: (2010)

Frictionless contact of a rigid punch indenting a transversely isotropic elastic layer
por: Rajesh Patra, et al.
Publicado: (2016-03-01)

Coiling of elastic rods on rigid substrates
por: Khalid Jawed, Mohammad
Publicado: (2015)

Coiling of elastic rods on rigid substrates
por: Khalid Jawed, Mohammad, et al.
Publicado: (2015)

Research on Adhesion Pull-Off Behavior of Rigid Flat Punch and Viscoelastic Substrate
por: Tao Zhang, et al.
Publicado: (2024-11-01)

On asymptotic rigidity and continuity problems in nonlinear elasticity on manifolds and hypersurfaces
por: Chen, GQG, et al.
Publicado: (2021)

Elastic fields of interacting point defects within an ultra-thin fcc film bonded to a rigid substrate
por: Shodja Hossein, et al.
Publicado: (2013-12-01)

Punching shear in flat slabs with re-entrant corner columns
por: João Paulo de Almeida Siqueira, et al.
Publicado: (2025-02-01)

Axisymmetric frictionless contact between an elastic layer thickness and a circular base under a rigid punch
por: Fadila Guerrache, et al.
Publicado: (2023-01-01)

Modeling of contact interaction of a heated plane rigid elliptical punch with a transversally isotropic elastic half-space
por: Vitaly S. Kirilyuk, et al.
Publicado: (2020-12-01)

On elastic contact problems of micro-periodic slant layered composite pressed by a rigid punch with a parabolic or rectangular shape
por: Piotr Sebestianiuk, et al.
Publicado: (2021-09-01)

Effect of load level of corner columns on punching shear resistance of flat slabs
por: Michał Gołdyn, et al.
Publicado: (2020-09-01)

A Viscous Fluid Flow through a Thin Channel with Mixed Rigid-Elastic Boundary: Variational and Asymptotic Analysis
por: R. Fares, et al.
Publicado: (2012-01-01)

Plastic instability and fracture in sheets stretched over rigid punches
por: Keeler, S. P. (Stuart P.)
Publicado: (2019)

The influence of punch blunting on the elastic indentation response
por: Korsunsky, A
Publicado: (2001)

The influence of punch blunting on the elastic indentation response
por: Korsunsky, A
Publicado: (2001)

The behaviour of elastic stress wave at rigid joints in impacted bar frames/
por: 397199 Atkins, A. J.
Publicado: (1974)

On asymptotic analysis of spectral problems in elasticity
por: S.A. Nazarov, et al.

CONTACT PROBLEM FOR PUNCH ON ELASTIC WEDGE WITH FREE EDGES
por: K. V. Dmitrieva
Publicado: (2010-08-01)

The numerical approximation for the indentation of granular materials by a smooth rigid wedge punch
por: Syafikah, Ayob
Publicado: (2022)

Stress analysis of the contact problem in a functionally graded layer loaded with a distributed load and two rigid circular punches resting on an elastic two quarter planes
por: Fatih Kaya, et al.
Publicado: (2023-05-01)

On rigidity of 3d asymptotic symmetry algebras
por: A. Farahmand Parsa, et al.
Publicado: (2019-03-01)

Influence of initial (residual) stresses on the contact interaction of an elastic cylindrical punch and the elastic layer
Publicado: (2016-07-01)

Alternative Formula for Rigid Pavement Stress Calculation in Corner Load Conditions
por: Saverio Olita, et al.
Publicado: (2020-12-01)

Flow-Induced Noise Characteristics Analysis of a Pipeline Structure in a Cabin Rigid Corner
por: Weihua Chen, et al.
Publicado: (2023-10-01)

The effect of contact aspect ratio and film to substrate elastic modulus ratio on stress vs. strain up to the point of yield during flat punch thin film indentation of an elastic-plastic film
por: Aaron D. Sinnott, et al.
Publicado: (2022-10-01)

Numerical And Experimental Analysis Of The Process Of Aviation Drawpiece Forming Using Rigid And Rubber Punch With Various Properties
por: Kut S., et al.
Publicado: (2015-09-01)

Sharp contact corners, fretting and cracks
por: D. A. Hills, et al.
Publicado: (2013-04-01)

Sharp contact corners, fretting and cracks
por: D. A. Hills, et al.
Publicado: (2013-07-01)

Cone crack initiation induced by contact from cylindrical punch
por: Xie, Y, et al.
Publicado: (2007)

Numerical approximation of plane deformation for the indentation of granular material by a smooth rigid wedge punch
por: Syafikah, Ayob, et al.
Publicado: (2019)

Influence of punch radius on elastic modulus of three-point bending tests
por: Pengliang Hou, et al.
Publicado: (2016-05-01)

The fracture moment of corner joints bonded by different glues
por: Jasna Hrovatin, et al.
Publicado: (2014-01-01)

Elastic Foundation Beam Analysis on Rigid Pavement and Piles
por: Arifin Syamsul, et al.
Publicado: (2020-01-01)

Vehicle behaviour in combined cornering and braking /
por: 187774 Harris, A. J., et al.

Asymptotic methods in the buckling theory of elastic shells /
por: 412269 Tovstik, Petr E., et al.
Publicado: (2001)

Bending of the rigidly fixed elastic-plastic plate
por: L.S. Assetova, et al.
Publicado: (2019-09-01)

Effect of small corner radius in cold punching of 22MnB5 die-quenched boron steel sheets
por: Hasnulhadi, Jaafar, et al.
Publicado: (2022)

THE JKR-ADHESIVE NORMAL CONTACT PROBLEM OF AXISYMMETRIC RIGID PUNCHES WITH A FLAT ANNULAR SHAPE OR CONCAVE PROFILES
por: Emanuel Willert, et al.
Publicado: (2016-12-01)