Asymptotic analysis of the corner-behaviour of a rigid punch bonded to an elastic substrate

Asymptotic analysis of the corner-behaviour of a rigid punch bonded to an elastic substrate

Bibliografske podrobnosti
Main Authors:	Bohrquez, L, Hills, D
Format:	Journal article
Izdano:	2007

Podobne knjige/članki

THE SOLUTION OF THE CONTACT BETWEEN A TILTED CIRCULAR RIGID PUNCH AND AN ELASTIC HALF-SPACE
od: Munisamy, R, et al.
Izdano: (1995)

Contact of a rigid cylinder indenting an elastic layer sliding over a rigid substrate
od: Reina, S, et al.
Izdano: (2010)

Frictionless contact of a rigid punch indenting a transversely isotropic elastic layer
od: Rajesh Patra, et al.
Izdano: (2016-03-01)

Coiling of elastic rods on rigid substrates
od: Khalid Jawed, Mohammad
Izdano: (2015)

Coiling of elastic rods on rigid substrates
od: Khalid Jawed, Mohammad, et al.
Izdano: (2015)

Research on Adhesion Pull-Off Behavior of Rigid Flat Punch and Viscoelastic Substrate
od: Tao Zhang, et al.
Izdano: (2024-11-01)

On asymptotic rigidity and continuity problems in nonlinear elasticity on manifolds and hypersurfaces
od: Chen, GQG, et al.
Izdano: (2021)

Elastic fields of interacting point defects within an ultra-thin fcc film bonded to a rigid substrate
od: Shodja Hossein, et al.
Izdano: (2013-12-01)

Punching shear in flat slabs with re-entrant corner columns
od: João Paulo de Almeida Siqueira, et al.
Izdano: (2025-02-01)

Axisymmetric frictionless contact between an elastic layer thickness and a circular base under a rigid punch
od: Fadila Guerrache, et al.
Izdano: (2023-01-01)

Modeling of contact interaction of a heated plane rigid elliptical punch with a transversally isotropic elastic half-space
od: Vitaly S. Kirilyuk, et al.
Izdano: (2020-12-01)

On elastic contact problems of micro-periodic slant layered composite pressed by a rigid punch with a parabolic or rectangular shape
od: Piotr Sebestianiuk, et al.
Izdano: (2021-09-01)

Effect of load level of corner columns on punching shear resistance of flat slabs
od: Michał Gołdyn, et al.
Izdano: (2020-09-01)

A Viscous Fluid Flow through a Thin Channel with Mixed Rigid-Elastic Boundary: Variational and Asymptotic Analysis
od: R. Fares, et al.
Izdano: (2012-01-01)

Plastic instability and fracture in sheets stretched over rigid punches
od: Keeler, S. P. (Stuart P.)
Izdano: (2019)

The influence of punch blunting on the elastic indentation response
od: Korsunsky, A
Izdano: (2001)

The influence of punch blunting on the elastic indentation response
od: Korsunsky, A
Izdano: (2001)

The behaviour of elastic stress wave at rigid joints in impacted bar frames/
od: 397199 Atkins, A. J.
Izdano: (1974)

On asymptotic analysis of spectral problems in elasticity
od: S.A. Nazarov, et al.

CONTACT PROBLEM FOR PUNCH ON ELASTIC WEDGE WITH FREE EDGES
od: K. V. Dmitrieva
Izdano: (2010-08-01)

The numerical approximation for the indentation of granular materials by a smooth rigid wedge punch
od: Syafikah, Ayob
Izdano: (2022)

Stress analysis of the contact problem in a functionally graded layer loaded with a distributed load and two rigid circular punches resting on an elastic two quarter planes
od: Fatih Kaya, et al.
Izdano: (2023-05-01)

On rigidity of 3d asymptotic symmetry algebras
od: A. Farahmand Parsa, et al.
Izdano: (2019-03-01)

Influence of initial (residual) stresses on the contact interaction of an elastic cylindrical punch and the elastic layer
Izdano: (2016-07-01)

Alternative Formula for Rigid Pavement Stress Calculation in Corner Load Conditions
od: Saverio Olita, et al.
Izdano: (2020-12-01)

Flow-Induced Noise Characteristics Analysis of a Pipeline Structure in a Cabin Rigid Corner
od: Weihua Chen, et al.
Izdano: (2023-10-01)

The effect of contact aspect ratio and film to substrate elastic modulus ratio on stress vs. strain up to the point of yield during flat punch thin film indentation of an elastic-plastic film
od: Aaron D. Sinnott, et al.
Izdano: (2022-10-01)

Numerical And Experimental Analysis Of The Process Of Aviation Drawpiece Forming Using Rigid And Rubber Punch With Various Properties
od: Kut S., et al.
Izdano: (2015-09-01)

Sharp contact corners, fretting and cracks
od: D. A. Hills, et al.
Izdano: (2013-04-01)

Sharp contact corners, fretting and cracks
od: D. A. Hills, et al.
Izdano: (2013-07-01)

Cone crack initiation induced by contact from cylindrical punch
od: Xie, Y, et al.
Izdano: (2007)

Numerical approximation of plane deformation for the indentation of granular material by a smooth rigid wedge punch
od: Syafikah, Ayob, et al.
Izdano: (2019)

Influence of punch radius on elastic modulus of three-point bending tests
od: Pengliang Hou, et al.
Izdano: (2016-05-01)

The fracture moment of corner joints bonded by different glues
od: Jasna Hrovatin, et al.
Izdano: (2014-01-01)

Elastic Foundation Beam Analysis on Rigid Pavement and Piles
od: Arifin Syamsul, et al.
Izdano: (2020-01-01)

Vehicle behaviour in combined cornering and braking /
od: 187774 Harris, A. J., et al.

Asymptotic methods in the buckling theory of elastic shells /
od: 412269 Tovstik, Petr E., et al.
Izdano: (2001)

Bending of the rigidly fixed elastic-plastic plate
od: L.S. Assetova, et al.
Izdano: (2019-09-01)

Effect of small corner radius in cold punching of 22MnB5 die-quenched boron steel sheets
od: Hasnulhadi, Jaafar, et al.
Izdano: (2022)

THE JKR-ADHESIVE NORMAL CONTACT PROBLEM OF AXISYMMETRIC RIGID PUNCHES WITH A FLAT ANNULAR SHAPE OR CONCAVE PROFILES
od: Emanuel Willert, et al.
Izdano: (2016-12-01)