Low pressure plasma-sprayed Al(2)O(3) and Al(2)O(3)/SiC nanocomposite coatings from different feedstock powders

Low pressure plasma-sprayed Al(2)O(3) and Al(2)O(3)/SiC nanocomposite coatings from different feedstock powders

This paper describes a preliminary investigation of a nanocomposite ceramic coating system, based on Al2O3/SiC. Feedstock Al2O3/SiC nanocomposite powder has been manufactured using sol-gel and conventional freeze-drying processing techniques and then low pressure plasma sprayed onto stainless steel...

Cur síos iomlán

Sonraí bibleagrafaíochta
Príomhchruthaitheoirí:	Jiansirisomboon, S, MacKenzie, K, Roberts, S, Grant, P
Formáid:	Journal article
Teanga:	English
Foilsithe / Cruthaithe:	2003

Míreanna comhchosúla

Low pressure plasma spraying of sol-gel Al2O3/SiC nanocomposite coatings
de réir: Jiansirisomboon, S, et al.
Foilsithe / Cruthaithe: (2001)

Subsurface deformation of machined Al2O3 and Al2O3/5vol%SiC nanocomposite.
de réir: Wu, H, et al.
Foilsithe / Cruthaithe: (2001)

Effects of Y2O3 additives and powder purity on the densification and grain boundary composition of Al2O3/SiC nanocomposites
de réir: Shapiro, I, et al.
Foilsithe / Cruthaithe: (2009)

PROCESSING AND PROPERTIES OF AL2O3/SIC NANOCOMPOSITES
de réir: Borsa, C, et al.
Foilsithe / Cruthaithe: (1995)

Corrosion behaviour of Al/SiC and Al/Al2O3 nanocomposites
de réir: Tamer Samir Mahmoud, et al.
Foilsithe / Cruthaithe: (2012-12-01)

Pressureless sintering and elastic constants of Al2O3-SiC 'nanocomposites'
de réir: Anya, C, et al.
Foilsithe / Cruthaithe: (1997)

An indentation model for erosive wear in Al2O3/SiC nanocomposites
de réir: Shapiro, I, et al.
Foilsithe / Cruthaithe: (2011)

The strength of Al2O3/SiC nanocomposites after grinding and annealing
de réir: Wu, H, et al.
Foilsithe / Cruthaithe: (1998)

Erosion resistance of hot pressed Al2O3/SiC nanocomposites
de réir: Lawrence, C, et al.
Foilsithe / Cruthaithe: (1998)

INSTRUMENTED INDENTATION OF Al2O3-SiC NANOCOMPOSITES
de réir: Csehova, E, et al.
Foilsithe / Cruthaithe: (2011)

Thermal shock of ground and polished alumina and Al(2)O(3)/SiC nanocomposites
de réir: Maensiri, S, et al.
Foilsithe / Cruthaithe: (2002)

INDENTATION LOAD-SIZE EFFECT IN Al2O3-SIC NANOCOMPOSITES
de réir: Csehova, E, et al.
Foilsithe / Cruthaithe: (2010)

Residual stress distributions around indentations and scratches in polycrystalline Al2O3 and Al2O3/SiC nanocomposites measured using fluorescence probes
de réir: Wu, H, et al.
Foilsithe / Cruthaithe: (2008)

Heterodefloculação no sistema Al2O3 - SiC Heterodeflocculation in the Al2O3 - SiC system
de réir: I. R. de Oliveira, et al.
Foilsithe / Cruthaithe: (1998-12-01)

Plasma spraying of Al2O3‑Al composite coatings
de réir: I. V. Rafalski, et al.
Foilsithe / Cruthaithe: (2023-12-01)

Interfacial fracture energy-mechanical behaviour relationship in Al2O3/SiC and Al2O3/TiN nanocomposites
de réir: Jiao, S, et al.
Foilsithe / Cruthaithe: (1997)

High resolution optical microprobe investigation of surface grinding stresses in Al2O3 and Al2O3/SiC nanocomposites
de réir: Guo, S, et al.
Foilsithe / Cruthaithe: (2011)

Hardness and indentation load-size effect in Al2O3-SiC nanocomposites
de réir: Csehova, E, et al.
Foilsithe / Cruthaithe: (2011)

Electron microscopy of crack/particle interactions in Al2O3/SiC nanocomposites
de réir: Jiao, S, et al.
Foilsithe / Cruthaithe: (1997)

Preparation of optimal feedstock for low-pressure injection molding of Al/SiC nanocomposite
de réir: Ghanbari Arezoo, et al.
Foilsithe / Cruthaithe: (2015-09-01)

Thermal microstress measurements in Al2O3/SiC nanocomposites by Cr3+ fluorescence microscopy
de réir: Merino, J, et al.
Foilsithe / Cruthaithe: (2003)

Processing and mechanical characterization of Al2O3/Ni and Al2O3/Co composites by pressureless sintering of nanocomposite powders
de réir: Betül Kafkaslioğlu Yildiz, et al.
Foilsithe / Cruthaithe: (2018-06-01)

Influence of processing on the microstructural development and flexure strength of Al2O3/SiC nanocomposites
de réir: Borsa, C, et al.
Foilsithe / Cruthaithe: (1997)

Fabrication of Al2O3/SiC/Al Hybrid Nanocomposites Through Solidification Process for Improved Mechanical Properties
de réir: Dapeng Jiang, et al.
Foilsithe / Cruthaithe: (2018-07-01)

Microstructure and Mechanical Properties of Al2O3-SiC Nanocomposites with 0.05% MgO and Different SiC Volume Fraction
de réir: Ali Reza Moradkhani, et al.
Foilsithe / Cruthaithe: (2012-06-01)

Analyzing and Modelling the Corrosion Behavior of Ni/Al2O3, Ni/SiC, Ni/ZrO2 and Ni/Graphene Nanocomposite Coatings
de réir: Nazir, M.H., et al.
Foilsithe / Cruthaithe: (2017)

Corrosion Resistance of Ni/Al2O3 Nanocomposite Coatings
de réir: Beata KUCHARSKA, et al.
Foilsithe / Cruthaithe: (2016-05-01)

Preparation and infrared stealth properties of SiO2/Al2O3 nanocomposite powders with low emissivity
de réir: CHEN Ke, et al.
Foilsithe / Cruthaithe: (2016-09-01)

Al2O3-TiN Nanocomposite powder synthesis using mechanochemical process
de réir: M. Godarzi, et al.
Foilsithe / Cruthaithe: (2011-12-01)

Thermal shock resistance of Al2O3 and Al2O3-13%TiO2 coatings deposited by supersonic atmospheric plasma spraying
de réir: FU Qianqian, et al.
Foilsithe / Cruthaithe: (2023-08-01)

Quantitative optical fluorescence microprobe measurements of stresses around indentations in Al2O3 and Al2O3/SiC nanocomposites: The influence of depth resolution and specimen translucency
de réir: Guo, S, et al.
Foilsithe / Cruthaithe: (2011)

Study and Analysis of Al2O3-SiC Nanocomposite Ceramics’ Fracture Toughness using Vickers Indenter
de réir: AliReza Moradkhani, et al.
Foilsithe / Cruthaithe: (2011-06-01)

Corrosion Behavior of Spark Plasma Sintered Alumina and Al2O3-SiC-CNT Hybrid Nanocomposite
de réir: Z.H. Al-Ashwan, et al.
Foilsithe / Cruthaithe: (2020-10-01)

SPRAY FORMING OF AL/SIC METAL-MATRIX COMPOSITES
de réir: Grant, P, et al.
Foilsithe / Cruthaithe: (1995)

The relationship between microstructure, fracture and abrasive wear in Al2O3/SiC nanocomposites and microcomposites containing 5 and 10% SiC
de réir: Limpichaipanit, A, et al.
Foilsithe / Cruthaithe: (2009)

Tribological Behavior of Plasma Sprayed Al2O3 and ZrO2 5CaO Coatings on Al-6061 Substrate
de réir: Krishnamurthy, N., et al.
Foilsithe / Cruthaithe: (2010-06-01)

Additive manufacturing of Al2O3 ceramics with MgO/SiC contents by laser powder bed fusion process
de réir: Asif Ur Rehman, et al.
Foilsithe / Cruthaithe: (2023-02-01)

Effect of powder grain size and titania content on mechanical and tribological properties of plasma sprayed Al2O3-TiO2 ceramic coatings
de réir: A. Góral, et al.
Foilsithe / Cruthaithe: (2019-03-01)

Experimental investigations of Al2O3- and ZrO2-based coatings deposited by detonation spraying
de réir: Bauyrzhan Rakhadilov, et al.
Foilsithe / Cruthaithe: (2021-01-01)

Mechanical and microstructural charaterization of YSZ/Al2O3 /CeO2 plasma Sprayed coatings
de réir: V. V. Satyamiryala Miryala, et al.
Foilsithe / Cruthaithe: (2022-09-01)