Detailed measurements of local heat transfer coefficient in the entrance to normal and inclined film cooling holes
The local heat transfer inside the entrance to large scale models of film cooling holes has been measured using the transient heat transfer technique. The method employs temperature sensitive liquid crystals to measure the surface temperature of large scale perspex models. Full distributions of loca...
| Main Authors: | , , , , , |
|---|---|
| 格式: | Journal article |
| 语言: | English |
| 出版: |
Publ by ASME
1994
|
| 总结: | The local heat transfer inside the entrance to large scale models of film cooling holes has been measured using the transient heat transfer technique. The method employs temperature sensitive liquid crystals to measure the surface temperature of large scale perspex models. Full distributions of local Nusselt number were calculated based on the cooling passage centreline gas temperature ahead of the cooling hole. The circumferentially averaged Nusselt number was also calculated based on the local mixed bulk driving gas temperature to aid interpretation of the results, and to broaden the potential application of the data. Data are presented for a single film cooling hole inclined at 90 and 150 degrees to the coolant duct wall. Both holes exhibited entry length heat transfer levels which were significantly lower than those predicted by entry length data in the presence of crossflow. The reasons for the comparative reduction are discussed in terms of the interpreted flow field. |
|---|