$Energy calibration and full-pattern refinement for strain analysis using energy-dispersive and monochromatic X-ray diffraction$

Energy calibration and full-pattern refinement for strain analysis using energy-dispersive and monochromatic X-ray diffraction

Precise channel-to-energy conversion is very important in full-pattern refinement in energy-dispersive X-ray diffraction. Careful examination shows that the channel-to-energy conversion is not entirely linear, which presents an obstacle to obtaining accurate quantitative data for lattice strains by...

Bibliografiset tiedot
Päätekijät:	Liu, J, Kim, K, Golshan, M, Laundy, D, Korsunsky, A
Aineistotyyppi:	Journal article
Kieli:	English
Julkaistu:	Wiley-Blackwell 2005
Aiheet:	Engineering and allied sciences

Samankaltaisia teoksia

Comparison of X-ray diffraction measurement of residual elastic strains: monochromatic beam and image plate versus white beam energy-dispersive analysis
Tekijä: Vorster, W, et al.
Julkaistu: (2007)

High energy white beam x-ray diffraction studies of residual strains in engineering components
Tekijä: Zhang, S, et al.
Julkaistu: (2008)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
Tekijä: Jun, T, et al.
Julkaistu: (2008)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
Tekijä: Golshan, M, et al.
Julkaistu: (2005)

Advanced strain analysis by high energy synchrotron X-ray diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (2002)

Comparison of X-ray diffraction measurement of residual elastic strains: monochromatic beam and image plate versus white beam energy-dispersive analysis
Tekijä: Vorster, W, et al.
Julkaistu: (2007)

Residual elastic strain due to laser shock peening: synchrotron diffraction measurement
Tekijä: Korsunsky, A, et al.
Julkaistu: (2006)

Fast residual stress mapping using energy-dispersive synchrotron X-ray diffraction on station 16.3 at the SRS
Tekijä: Korsunsky, A, et al.
Julkaistu: (2002)

Mapping two-dimensional state of strain using synchrotron x-ray diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (1998)

High energy transmission micro-beam Laue synchrotron X-ray diffraction
Tekijä: Hofmann, F, et al.
Julkaistu: (2010)

Strain gradient polycrystal plasticity analysis: Fe modeling and synchrotron X-ray diffraction
Tekijä: Song, X, et al.
Julkaistu: (2010)

Intergranular lattice misorientation mapping by synchrotron x-ray micro-beams: Laue vs energy-resolved Laue vs monochromatic reciprocal space analysis
Tekijä: Hofmann, F, et al.
Julkaistu: (2010)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
Tekijä: Salimon, A, et al.
Julkaistu: (2000)

Residual stresses in an induction hardened gear tooth mapped by synchrotron X-ray diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (2003)

Polycrystal deformation analysis by high energy synchrotron X-ray diffraction on the I12 JEEP beamline at Diamond Light Source
Tekijä: Korsunsky, A, et al.
Julkaistu: (2010)

High energy white beam x-ray diffraction studies of residual strains in engineering components
Tekijä: Zhang, S, et al.
Julkaistu: (2008)

The principle of strain reconstruction tomography: determination of quench strain distribution from diffraction measurements
Tekijä: Korsunsky, A, et al.
Julkaistu: (2006)

High energy white beam x-ray diffraction studies of residual strains in engineering components
Tekijä: Zhang, S, et al.
Julkaistu: (2007)

Residual strain measurement by synchrotron diffraction
Tekijä: Withers, P, et al.
Julkaistu: (2002)

High energy synchrotron X-ray measurements of 2D residual stress states in metal matrix composites
Tekijä: Korsunsky, A, et al.
Julkaistu: (2000)

Oxford HEXameter: laboratory high energy X-ray diffractometer for bulk residual stress analysis
Tekijä: Korsunsky, A, et al.
Julkaistu: (2006)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
Tekijä: Korsunsky, A, et al.
Julkaistu: (2007)

Damage-plasticity modelling of concrete: calibration of parameters using separation of fracture energy
Tekijä: Nguyen, G, et al.
Julkaistu: (2006)

A comparative study of diffraction methods for strain measurement in a particulate MMC
Tekijä: Korsunsky, A, et al.
Julkaistu: (2000)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
Tekijä: Korsunsky, A
Julkaistu: (2006)

Triaxial residual strains in a railway rail measured by neutron diffraction
Tekijä: Jun, T, et al.
Julkaistu: (2009)

Diffraction strain measurements for the characterization of residual stresses in welds for gas turbine applications
Tekijä: Dye, D, et al.
Julkaistu: (2003)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
Tekijä: Jun, T, et al.
Julkaistu: (2008)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
Tekijä: Golshan, M, et al.
Julkaistu: (2005)

High energy white beam x-ray diffraction studies of strains in engineering materials and components
Tekijä: Zhang, SY
Julkaistu: (2008)

Diffraction post-processor for polycrystalline plasticity modelling
Tekijä: Dini, D, et al.
Julkaistu: (2006)

Advanced strain analysis by high energy synchrotron X-ray diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (2002)

Finite element modelling and diffraction measurement of elastic strains during tensile deformation of HCP polycrystals
Tekijä: Song, X, et al.
Julkaistu: (2008)

Neutron diffraction measurement and finite element modelling of residual strains due to bath and spray quenching of AISI 316L stainless steel cylinders
Tekijä: Vorster, W, et al.
Julkaistu: (2008)

Intergranular stresses in polycrystalline fatigue: diffraction measurement and self-consistent modelling
Tekijä: Korsunsky, A, et al.
Julkaistu: (2003)

Measurement of residual elastic strains in a titanium alloy using high energy synchrotron X-ray diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (2006)

Residual stresses in induction-hardened gear teeth mapped by neutron diffraction
Tekijä: Korsunsky, A, et al.
Julkaistu: (2002)

Elastoplastic deformation of two phase steels studied by neutron diffraction and self-consistent modelling
Tekijä: Daymond, M, et al.
Julkaistu: (2002)

Inter-granular residual stresses in polycrystalline aggregates: finite element modelling and diffraction post-processing
Tekijä: Song, X, et al.
Julkaistu: (2008)

Neutron diffraction analysis of stresses in an in-plane biaxially-fatigued stainless steel sample of cruciform geometry
Tekijä: Taran, Y, et al.
Julkaistu: (2008)