Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders

Pokaż inne wersje (1)

A number of elemental mixtures have initial compositions close to Al₆₅Cu₂₃Fe₁₂ were mechanically alloyed at different energy intensities using a planetary mill. Laboratory X-ray diffraction analysis, differential scanning calorimetry and Mössbauer spectroscopy were used for characterization of the p...

Szczegółowa specyfikacja

Opis bibliograficzny
Główni autorzy:	Salimon, A, Korsunsky, A, Shelekhov, E, Sviridova, T, Kaloshkin, S, Tcherdyntsev, V, Baldokhin, Y
Kolejni autorzy:	Acta Materialia Inc.
Format:	Journal article
Język:	English
Wydane:	Pergamon 2001
Hasła przedmiotowe:	Engineering & allied sciences

Podobne zapisy

Crystallochemical aspects of solid state reactions in mechanically alloyed Al-Cu-Fe quasicrystalline powders
od: Salimon, A, i wsp.
Wydane: (2001)

The evolution of crystalline precursors during the formation of Al-Cu-Fe quasicrystalline intermetallics in mechanically alloyed powders
od: Salimon, A, i wsp.
Wydane: (2001)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
od: Tcherdyntsev, V, i wsp.
Wydane: (2002)

The evolution of crystalline precursors during the formation of Al-Cu-Fe quasicrystalline intermetallics in mechanically alloyed powders
od: Salimon, A, i wsp.
Wydane: (2001)

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
od: Korsunsky, A, i wsp.
Wydane: (2001)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
od: Salimon, A, i wsp.
Wydane: (2000)

Quasicrystalline phase formation by heating a mechanically alloyed Al65Cu23Fe12 powder mixture
od: Tcherdyntsev, V, i wsp.
Wydane: (2002)

The thermal expansion coefficient of mechanically alloyed Al-Cu-Fe quasicrystalline powders
od: Korsunsky, A, i wsp.
Wydane: (2001)

Preparation and analysis of quasicrystalline phases by high energy ball milling and X-ray diffraction
od: Salimon, A, i wsp.
Wydane: (2000)

The evolution of electrochemical, microstructural, and mechanical properties of aluminium alloy 2024-T4 (D16AT) during fatigue cycling
od: Salimon, S, i wsp.
Wydane: (2010)

The character of dislocation structure evolution in nanocrystalline FCC Ni-Co alloys prepared by high-energy mechanical milling
od: Salimon, A, i wsp.
Wydane: (1999)

Quasicrystalline Phase Formation of the Al67Cu26Fe15 Alloy
od: Luciano Nascimento, i wsp.
Wydane: (2019-06-01)

The Effect of Transition Metals on Quasicrystalline Phase Formation in Mechanically Alloyed Al65Cu20Fe15 Powder
od: M. Mitka, i wsp.
Wydane: (2020-07-01)

Structure and High-Temperature Properties of the Alloyed Quasicrystalline Al-Cu-Fe Powders and Thermal-Sprayed Coatings from Them
od: Iefimov, M.O., i wsp.
Wydane: (2006-04-01)

Impact fracture thresholds in brittle solids
od: Korsunsky, A, i wsp.
Wydane: (1995)

Variational eigenstrain analysis of synchrotron diffraction measurements of residual elastic strain in a bent titanium alloy bar
od: Korsunsky, A
Wydane: (2006)

Strain gradient polycrystal plasticity analysis: Fe modeling and synchrotron X-ray diffraction
od: Song, X, i wsp.
Wydane: (2010)

Dissipated energy and friction coefficient evolution during fretting wear of solid lubricant coatings
od: Korsunsky, A, i wsp.
Wydane: (2009)

The correlation between plastic strain and anisotopy strain in aluminium alloy polycrystals
od: Korsunsky, A, i wsp.
Wydane: (2002)

Strengthening mechanisms in an Al-Fe-Cr-Ti nano-quasicrystalline alloy and composites
od: Pedrazzini, S, i wsp.
Wydane: (2016)

Analysis of residual stresses around 'dimpled' cold-expanded holes in aluminum alloy plates
od: Zhang, S, i wsp.
Wydane: (2008)

Strengthening mechanisms in an Al-Fe-Cr-Ti nano-quasicrystalline alloy and composites
od: Pedrazzini, S, i wsp.
Wydane: (2016)

Crack growth micro-mechanisms in the IN718 alloy under the combined influence of fatigue, creep and oxidation
od: Prakash, D, i wsp.
Wydane: (2009)

A study of residual elastic strain distribution in an AZ91 Mg alloy bar loaded in four point bending
od: Prakash, D, i wsp.
Wydane: (2008)

Crystallochemical Design of Huntite-Family Compounds
od: Galina M. Kuz’micheva, i wsp.
Wydane: (2019-02-01)

Residual stresses in rolled and machined nickel alloy plates: synchrotron X-ray diffraction measurement and three-dimensional eigenstrain analysis
od: Korsunsky, A, i wsp.
Wydane: (2007)

Analysis of plastic deformation and residual elastic strain in a titanium alloy using synchrotron x-ray diffraction
od: Golshan, M, i wsp.
Wydane: (2005)

Synchrotron energy-dispersive X-ray diffraction analysis of residual strains around friction welds between dissimilar aluminium and nickel alloys
od: Jun, T, i wsp.
Wydane: (2008)

Use of XRD technique to investigate the stability of quasicrystalline phase in high-energy milled Al/AlCuFe powders
od: K.S. Evangelista, i wsp.
Wydane: (2021-11-01)

Engineering at large scale: Experience from diamond light source
od: Korsunsky, A, i wsp.
Wydane: (2010)

Structure Formation and Corrosion Behaviour of Quasicrystalline Al–Ni–Fe Alloys
od: O. V. Sukhova, i wsp.
Wydane: (2018-01-01)

Microstructure and chemistry of annealed Al-Cu-Fe-Cr quasicrystalline approximant coatings
od: Daniels, M, i wsp.
Wydane: (2005)

Al62Cu25Fe12 and Quasicrystalline Phases and Their Influence on Oxidation
od: Lourdes Cristina Lucena A. Jamshidi, i wsp.
Wydane: (2017-03-01)

The influence of punch blunting on the elastic indentation response
od: Korsunsky, A
Wydane: (2001)

Debonding of a weak interface in front of a through-thickness crack
od: Korsunsky, A
Wydane: (2001)

On the size effects and scale transitions in the strength and failure of materials and structures
od: Korsunsky, A
Wydane: (2009)

The Somigliana ring dislocation revisited: 1. Papkovich potential solutions for dislocations in an infinite space
od: Korsunsky, A
Wydane: (1996)

On the use of interpolative quadratures for hypersingular integrals in fracture mechanics
od: Korsunsky, A
Wydane: (2002)

Residual elastic strain due to laser shock peening: modelling by eigenstrain distribution
od: Korsunsky, A
Wydane: (2006)

Residual elastic strains in autofrettaged tubes: elastic-ideally plastic model analysis
od: Korsunsky, A
Wydane: (2007)