Kesan parameter pemesinan ke atas pembentukan serpihan semasa mengisar hujung keluli terkeras aisi H 13 menggunakan mata alat sermet
The effect of machining parameters on chip formation during end milling AISI H13 tool steels using cermet inserts was investigated. The machining range were set at speed of 224- 355 m min-1, feed rate of 0.1-0.25 mm tooth-1 and radial depth of cut of 0.3 -0.8 mm. The SEM analysis shows that'...
Main Authors: | Jaharah A. Ghani, M.Z.Hanif |
---|---|
Format: | Article |
Published: |
2004
|
Similar Items
-
Kajian keutuhan permukaan hasil proses mengisar halus ke atas keluli alat /
by: 395001 Adam Malik
Published: (1999) -
Kajian keutuhan permukaan hasil proses mengisar halus ke atas keluli alat
by: Malik, Adam
Published: (1999) -
Kajian keutuhan permukaan hasil proses mengisar halus ke atas keluli alat [microfilm] /
by: Adam Malik
Published: (1999) -
Rekabentuk mesin pemisah serpihan pemotongan daripada hasilkerja pemesinan /
by: 304474 Mohd. Kashfullah Razali
Published: (2002) -
Pembangunan Mata Alat Seramik Untuk Pemesinan Keluli Aloi
by: Lubis, Muhammad Sobron Yamin
Published: (2008)