Stress distribution analysis on semi constrained elbow prosthesis during flexion and extension motion

Stress distribution analysis on semi constrained elbow prosthesis during flexion and extension motion

Show other versions (1)

Bibliographic Details
Main Authors:	Heidari, M., Abdul Kadir, M. R., Fallahiarezoodar, A., Alizadeh, M.
Format:	Article
Published:	Springer 2011
Subjects:	TA Engineering (General). Civil engineering (General)

Similar Items

Stress distribution analysis on semi constrained elbow prosthesis during flexion and extension motion
by: Abdul Kadir, Mohammed Rafiq, et al.
Published: (2011)

Stress distribution analysis on semi constrained elbow prosthesis during flexion and extension motion
by: Mohammed Rafiq Abdul Kadir
Published: (2011)

Analysis of burst pressure on elbow and t-section in the presence of defect
by: Adzmil, Abdul Aziz
Published: (2013)

Development of novel polymer composite beam using ultrasonic welding process for acetabular cup prosthesis
by: Goharian, Amirhossein, et al.
Published: (2011)

Investigation of flow in elbow pipe using lattice Boltzmann method
by: Nik Muqaffi, Nik Jaffar
Published: (2009)

Kinematic comparison of the wrist movements that are possible with a biomechatronics wrist prosthesis and a body-powered prosthesis: a preliminary study
by: Abd Razak, N.A., et al.
Published: (2012)

3-D finite-element analysis of fiber-reinforced soft bending actuator for finger flexion
by: Mohd. Faudzi, Ahmad Athif
Published: (2013)

Satisfaction and problems experienced with wrist movements: comparison between a common body-powered prosthesis and a new biomechatronics prosthesis
by: Abd Razak, N.A., et al.
Published: (2014)

Video imaging measurement of interfacial wave velocity in air-water flow through a horizontal elbow
by: Al-Wazzan, A., et al.
Published: (2001)

Finite element analysis on longitudinal and radial functionally graded femoral prosthesis
by: Oshkour, Azim Ataollahi, et al.
Published: (2013)

A new pylon materials in transtibial prosthesis: a preliminary study
by: Shasmin, H.N., et al.
Published: (2007)

Kinematic comparison of the wrist movements that are possible with a biomechatronics wrist prosthesis and a body-powered prosthesis: a preliminary study
by: Abd Razak, N.A., et al.
Published: (2013)

Biomechanical assessment of unconstrained elbow prosthesis after total elbow replacement: a finite element analysis
by: Heidari, Milad, et al.
Published: (2012)

Finite element analysis of circumferential crack behavior in cement-femoral prosthesis interface
by: Oshkour, A.A., et al.
Published: (2013)

Effect of wall thinning on deformation and failure of copper nickel alloy elbows subjected to low cycle fatigue
by: Harun, Muhammad Faiz, et al.
Published: (2019)

A new approach for the pistoning measurement in transtibial prosthesis
by: Gholizadeh, Hossein, et al.
Published: (2011)

Interference and inefficiency of water wells: a constrain of water conservation in Bangladesh
by: Sattar, G. S., et al.
Published: (2017)

Flexion relaxation phenomenon of back muscles in discriminating between healthy and chronic low back pain women
by: Othman, S.H., et al.
Published: (2008)

Validation of finite element analysis for a new external finger fixator to correct flexion deformity - a preliminary result
by: Abd Rahman, H.S., et al.
Published: (2008)

Constraining the far-field maximum horizontal stress in the plate tectonic area
by: Ali, Wahid
Published: (2022)

Selection Of Multiple Earthquakes Considering Vertical Ground Motion To Structures
by: A., Taib, et al.
Published: (2017)

Influence of flow shallowness on scour depth at semi-integral bridge piers
by: Akib, Shatirah, et al.
Published: (2011)

Development of cement-bitumen composites for semi-flexible pavement surfacing
by: Koting, S., et al.
Published: (2011)

Semi-distributed neural network models for streamflow prediction in a small catchment pinang
by: Suliman, Ali H. Ahmed, et al.
Published: (2019)

Calibration and validation of reference evapotranspiration models in semi-arid conditions
by: Islam, S., et al.
Published: (2020)

Preliminary modelling assessment of hydrodynamic simulation due to Terengganu Airport Runway Extension
by: Soh, Y. L., et al.
Published: (2019)

Biomechanics analysis of kicking motion
by: Mohd Haziq, Nordin
Published: (2013)

Lifetime extension of ageing offshore structures by global ultimate strength assessment (GUSA)
by: Abu Husain, Mohd. Khairi, et al.
Published: (2018)

Evaluation of remotely sensed precipitation sources for drought assessment in semi-arid Iraq
by: Suliman, A. H. A., et al.
Published: (2020)

Conceptual design of semi-automatic wheelbarrow to overcome ergonomics problems among palm oil plantation workers
by: Nawik, N. S. M., et al.
Published: (2015)

Motion detection in stereoscopic vision system
by: Adam, Mohamad Zulkefli
Published: (1999)

Applying dual-tree complex discrete wavelet transform and gamma modulating function for simulation of ground motions
by: Sharbati, R., et al.
Published: (2021)

Column design with semi-rigid end frame
by: Wan Jusoh, Wan Hidayatul Hak
Published: (2010)

Motion planning of hyper redundant manipulators based on a new geometrical method
by: Yahya, S., et al.
Published: (2009)

Streamflow modeling of a large arid catchment using semi-distributed hydrological model and modular neural network
by: Jajarmizadeh, Milad
Published: (2013)

Preliminary analysis of knee stress in full extension landing
by: Makinejad, M.D., et al.
Published: (2013)

Auto pan tilt motion surveillance system
by: Pei, Song Chee, et al.
Published: (2011)

Development of an image rotary encoder for motion control
by: Ismayuzri, Ishak
Published: (2013)

Semi-active suspension system for off-road vehicles
by: BenLahcene, Zohir, et al.
Published: (2011)

Prediction of evaporation in arid and semi-arid regions: a comparative study using different machine learning models
by: Yaseen, Z. M., et al.
Published: (2020)